Bedienungsanleitung Piazzetta P960 (Seite 13 von 64) (Englisch)

643476

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

The clearance to a door, window or cavity must be at least:

- 1.5’ (458 mm) below;

- 1.5’ (458 mm) horizontally;

- 9’’ (230 mm) above.

The clearance to fresh air intake for combustion of the pellet stove

or any other appliance, or the non-mechanical air supply inlet to the

building must be at least 4’ (1.2 m).

The clearance to a mechanical air supply inlet to the building must be

at least 8’ (2.5 m).

•The exhaust termination location (Fig. 20) must be at least:

- 1’ (305 mm) above the ground level. Attention : the minimum vertical

rise shall always be not less than 5’ (1.5 m).

A ue at 1’ above ground is not enfant safe: we strongly reccomend

that the exhaust termination of ue be raised another 4’ to avoid

injury.

- 7’ (2.1 m) from a public walkway, but attention to where the vent

shall end its course, as it is not to be in between or serve two family

dwellings and/or directly above side-walks or paved driveways;

- 1’ (305 mm) from the wall penetration point;

- 3’ (915 mm) from a gas meter/regulator assembly;

- 3’ (915 mm) from any adjacent combustibles such as: adjacent

buildings, fences, protruding parts of the structure, roof eaves or

overhangs, plants, shrubs, etc.

a The exhaust gases from the combustion of pellets fuel may

dirty the outside of the walls.

To avoid such possibility terminate the vent above the roof

line.

a Ensure that all installation work is carried out to professional

standards.

PUBLIC

WALKWAY

COMBUSTIBLES

CLEARANCE TO

PUBLIC WALKWAY

CLEARANCE TO WALL

PENETRATION POINT

CLEARANCE TO

COMBUSTIBLES

CLEARANCE TO

GROUND

TEE

VENT

90° ELBOW

THIMBLE

45° ELBOW

WITH

TERMINATION

COLLAR

Fig. 20

The product must be installed and used in compliance with the manufacturer’s instructions and national standards as well as local regulations.

a When a ue pipe passes through a wall or a ceiling, special installation methods must be applied (protection, thermal insulation,

distances from heat-sensitive materials, etc.) See the paragraph from “INTERIOR VENT INSTALLATION” to “SHORT RISE INSTALLATION

- WALL OUTLET”.

•It is also recommended that all elements made of combustible or inammable material, such as beams, wooden furniture, curtaining, ammable

liquids, etc. be kept outside the heat radiation range of the stove and at a distance of at least 32” / 80 cm from the heating block.

•For other information, see the paragraph from “MINIMUM SAFETY DISTANCES” to “VENTING: TERMINATION REQUIREMENTS”.

•The ue pipe, chimney stack, chimney and fresh air intake must always be free of obstructions, clean and checked periodically, that is, at least

twice during the seasonal period from the lighting of the stove and during its use. When the stove has not been used for some time it is advisable

to carry out the checks mentioned above. For further information, consult a chimneysweep.

•Only use recommended fuels (See section “FUEL”).

DT2010027-02

1.13 PREvENTION OF dOMESTIC FIRES

H07028100/DT2000970 – 01

English

DT2033042-00

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Piazzetta P960 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info