Bedienungsanleitung Pinarello Nytro Dust 2021 (Seite 16 von 30) (Englisch)

780497

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

7. GENERAL MAINTENANCE AND CARE

Your Pinarello Nytro Dust bicycle is a high quality product. Nevertheless, and precisely for this

reason, it requires continuous correct care and regular maintenance by a specialist to keep it in

perfect operation over the long term.

GENERAL CLEANING AND MAINTENANCE

Dirt, sweat, sea salt and salt from winter roads will damage your pedelec, meaning that the bike

and its components require regular cleaning to protect them from corrosion.

Never clean your bike with pressure washers. These force water into seals and bearings, washing

out lubricants and thus increasing friction on moving parts, causing rapid corrosion and wear.

The better way to clean your bike is to use a gentle flow of water and a sponge or brush. This will

also enable close inspection of the bike, for early detection of signs of wear, fatigue or damage.

The MOST® product line includes all the suitable products for cleaning, care and lubricating your

bicycle.

After cleaning, check the chain, and if necessary lubricate it with the appropriate products.

During cleaning, pay attention to any cracks, scratches, altered paint or

deformations of materials in the components. If in doubt, have the bike

inspected by your trusted Pinarello dealer, who can provide assistance, and

where necessary, replace the damaged components.

Only use products specific to bicycle care. Aggressive, non-neutral degreasers

or chemical detergents could cause cosmetic, surface damage, or worse,

alter the characteristics of important components such as moving parts and

bearings.

The motor action leads to faster chain wear than on regular muscle-powered

bikes. Before each ride, inspect the chain for wear.

Do not apply cleaning and care products or chain lubricant to the brake pads

or discs. This could reduce the braking performance and pose a serious safety

hazard.

CLEANING THE FRONT FORK

After each ride: clean dirt and debris from the upper tubes and dust seals; check air pressure and

inspect the upper tubes for scratches. After every 50 hours of use: service the chainstay at your

authorised Pinarello dealer. After every 200 hours of use: service the spring and damper assembly.

Refer to the fork manufacturer’s manual for more details.

CLEANING THE REAR SUSPENSION

Clean the shock absorber with water and mild detergent. Never clean the shock with pressure

washers. To maintain the high performance, safety and long life of your rear suspension,

periodically check tightening torques, perform routine maintenance on the shock, and service

and grease the linkage system. Refer to the rear shock manufacturer’s manual for maintenance

intervals and procedures. In any case, we advise you to refer to your trusted Pinarello dealer to

carry out maintenance operations.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pinarello Nytro Dust 2021 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pinarello Nytro Dust 2021

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info