Bedienungsanleitung Pioneer AVH-X3500DAB (Seite 2 von 64) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

528308

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

< CRD4846-A >

Precautions

Your new product and this

manual

Do not operate this product, any appli-

cations, or the rear view camera option

(if purchased) if doing so will divert your

attention in any way from the safe opera-

tion of your vehicle. Always observe safe

driving rules and follow all existing traffic

regulations. If you experience difficulty

in operating this product or reading the

display, park your vehicle in a safe loca-

tion and apply the parking brake before

making the necessary adjustments.

Do not install this product where it may

(i) obstruct the driver’s vision, (ii) impair

the performance of any of the vehicle’s

operating systems of safety features,

including airbags, hazard lamp buttons,

or (iii) impair the driver’s ability to safely

operate the vehicle. In some cases, it may

not be possible to install this product

because of the vehicle type or the shape

of the vehicle interior.

Important safeguards

WARNING

Pioneer does not recommend that you

install this product yourself. This prod-

uct is designed for professional instal-

lation only. We recommend that only

authorized Pioneer service personnel,

who have special training and experi-

ence in mobile electronics, set up and

install this product. NEVER SERVICE

THIS PRODUCT YOURSELF. Installing

or servicing this product and its connect-

ing cables may expose you to the risk of

electric shock or other hazards, and can

cause damage to this product that is not

covered by warranty.

Connection

Precautions before connecting

the system

WARNING

Do not take any steps to tamper with or

disable the parking brake interlock sys-

tem which is in place for your protection.

Tampering with or disabling the parking

brake interlock system could result in

serious injury or death.

CAUTION

Secure all wiring with cable clamps

or electrical tape. Do not allow any

bare wiring to remain exposed.

Do not directly connect the yellow

lead of this product to the vehicle

battery. If the lead is directly con-

nected to the battery, engine vibra-

tion may eventually cause the insula-

tion to fail at the point where the wire

passes from the passenger compart-

ment into the engine compartment. If

the yellow lead’s insulation tears as

a result of contact with metal parts,

short-circuiting can occur, resulting

in considerable danger.

It is extremely dangerous to allow

cables to become wound around the

steering column or shift lever. Be

sure to install this product, its cables,

and wiring away in such so that they

will not obstruct or hinder driving.

Make sure that the cables and wires

will not interfere with or become

caught in any of the vehicle’s moving

parts, especially the steering wheel,

shift lever, parking brake, sliding seat

tracks, doors, or any of the vehicle’s

controls.

Do not route wires where they will

be exposed to high temperatures. If

the insulation heats up, wires may

become damaged, resulting in a short

circuit or malfunction and permanent

damage to the product.

Do not shorten any leads. If you do,

the protection circuit (fuse holder,

fuse resistor or filter, etc.) may fail to

work properly.

Never feed power to other electronic

products by cutting the insulation of

the power supply lead of this prod-

uct and tapping into the lead. The

current capacity of the lead will be

exceeded, causing overheating.

Before installing this product

Use this unit with a 12-volt battery and

negative grounding only. Failure to do so

may result in a fire or malfunction.

To avoid shorts in the electrical system,

be sure to disconnect the (–) battery

cable before installation.

To prevent damage

WARNING

Use speakers over 50 W (output

value) and between 4 W to 8 W

(impedance value). Do not use 1 W to

3 W speakers for this unit.

The black lead is ground. Please

ground this lead separately from

the ground of high-current products

such as power amps. Do not ground

more than one product together with

the ground from another product.

For example, you must separately

ground any amp unit away from the

ground of this product. Connecting

grounds together can cause a fire

and/or damage the products if their

grounds became detached.

When replacing the fuse, be sure

to only use a fuse of the rating pre-

scribed on this product.

This product cannot be installed in a

vehicle without ACC (accessory) position

on the ignition switch.

ACC position No ACC position

To avoid short-circuiting, cover the

disconnected lead with insulating tape.

It is especially important to insulate all

unused speaker leads, which if left uncov-

ered may cause a short circuit.

For connecting a power amp or other

devices to this product, refer to the man-

ual for the product to be connected.

■ Notice for the blue/white lead

When the ignition switch is turned on

(ACC ON), a control signal is output

through the blue/white lead. Connect to

an external power amp’s system remote

control terminal, the auto-antenna relay

control terminal, or the antenna booster

power control terminal (max. 300 mA

12 V DC). The control signal is output

through the blue/white lead, even if the

audio source is switched off.

CRD4846-A_2

Pioneer AVH-X3500DAB Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer AVH-X3500DAB

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info