Bedienungsanleitung Pioneer AVIC-HD3 II (Seite 158 von 193) (Englisch)

491808

158

Zoom out

Zoom in

Vorherige Seite

1/193

Nächste Seite

You cannot position your vehicle

on the map or the positioning

error is large.

The quality of signals from the GPS

satellites is poor, causing reduced

positioning accuracy. Such a loss of

signal quality may happen for the

following reasons:

• If a vehicle phone or mobile

phone is used near the GPS aerial,

GPS reception may be lost tempora-

rily.

• Do not cover the GPS aerial with

spray paint or vehicle wax, because

this may block the reception of GPS

signals. Snow buildup can also de-

grade the signals.

Check the GPS signal reception and the posi-

tion of the GPS aerial if necessary, or con-

tinue driving until reception improves. Keep

the aerial clear. (Page 79)

Signals from the vehicle’s speed

pulse are not being picked up prop-

erly.

Check that the cables are properly connected.

If necessary, consult the dealer that installed

the system.

The navigation system may not be

mounted securely in your vehicle.

Check that the navigation system is securely

mounted and, if necessary, consult the dealer

that installed the system.

Your vehicle is operating in Simple

hybrid mode.

Connect the speed signal input (pink lead

wire) of the power cable correctly, and reset

the 3D Hybrid Sensor memory ([Learning

Status]).

The navigation system is installed

with an extreme angle exceeding

the limitation of the installation

angle.

Confirm the installation angle. (The naviga-

tion system must be installed within the al-

lowed installation angle. For details, refer to

“Installation Manual” and [Installation

Angle Setup].) (Page 81)

Indication of the position of your ve-

hicle is misaligned after a U-turn or

reversing.

Check whether or not the reverse gear signal

input lead (violet) is connected properly. (The

navigation system works properly without the

lead connected, but positioning accuracy will

be adversely affected.)

The map continually reorients it-

self.

The travelling direction is always set

to Heading Up.

Touch

on the screen and change the map

display.

The daylight display is used

even when the vehicle lights are

on.

[Day] is selected to [Day/Night Dis-

play].

Check [Day/Night Display] setting and make

sure [Automatic] is selected. (Page 46)

The orange/white lead is not con-

nected.

Check the connection.

The display is very dim. The vehicle ’s light is turned ON, and

[Automatic] is selected on [Day/

Night Display].

Read about [Day/Night Display] setting and,

if desired, select [Day]. (Page 46)

The vehicle cabin temperature is ex-

tremely low.

A Liquid Crystal Display (LCD) is used, and

such displays tend to darken when cold. Wait

for the vehicle to warm up.

Picture quality adjustment of the

display is not correct.

Adjust the picture quality. (Page 138)

Display tilt is not at the proper set-

ting.

Press and hold EJECT button to adjust the tilt.

Appendix

Engb

158

Appendix

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer AVIC-HD3 II Seite 158

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer AVIC-HD3 II

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info