Bedienungsanleitung Pioneer CNDV-50MT (Seite 119 von 142) (Englisch)

454962

119

Zoom out

Zoom in

Vorherige Seite

1/142

Nächste Seite

117

AppendixNAVI/AV

Troubleshooting

If you have problems operating your Navigation System, refer to this section. The most common

problems are listed below, along with likely causes and solutions. While this list is not comprehensive,

it should answer your most common problems. If a solution to your problem cannot be found here,

contact your dealer or the nearest authorised Pioneer service facility.

Problems in the navigation screen

Symptom Cause Action (See)

Power doesn’t turn on.

The unit doesn’t operate.

Leads and connectors are incorrectly

connected.

Confirm once more that all

connections are correct.

The fuse is blown. Rectify the reason for the fuse

blowing, then replace the fuse. Be

very sure to install the correct fuse

with the same rate.

Noise and other factors are causing

the built-in microprocessor to

operate incorrectly.

Press RESET button. (

➞ “HardWare

Manual” and refer to page 116 in this

manual.)

There’s no sound.

Volume level is low.

The volume level is low. Adjust the

volume level.

The attenuator is on. Turn the

attenuator off.

When the ignition switch is turned

ON (or turned to ACC), the motor

sounds.

This unit confirms whether a disc is

loaded or not.

This is a normal operation.

You cannot position your vehicle on

the map or the positioning error is

large.

The quality of signals from the GPS

satellites is poor, causing reduced

positioning accuracy. Such a loss of

signal quality may happen for the

following reasons:

• The GPS aerial is in an unsuitable

location.

• Obstacles are blocking signals

from the satellites.

• The position of satellites relative to

your vehicle is bad.

• Signals from the GPS satellites

have been modified to reduce

accuracy. (GPS satellites are

operated by the US Department of

Defense, and the US government

reserves the right to distort

positioning data for military reasons.

This may lead to greater positioning

errors.)

• If a vehicle phone or cellular phone

is used near the GPS aerial, GPS

reception may be lost temporarily.

• Do not cover the GPS aerial with

spray paint or vehicle wax, because

this may block the reception of GPS

signals. Snow buildup can also

degrade the signals.

Check the GPS signal reception (

➞

Page 52) and the position of the GPS

aerial if necessary, or continue

driving until reception improves.

Keep the aerial clear.

Signals from the vehicle’s speed

pulse are not being picked up

properly.

Check that the cables are properly

connected. If necessary, consult the

dealer that installed the system.

The navigation unit may not be

mounted securely in your vehicle.

Check that the navigation unit is

securely mounted and, if necessary,

consult the dealer that installed the

system.

MAN-CNDV-50MT-EN.book Page 117 Wednesday, May 4, 2005 1:49 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer CNDV-50MT Seite 119

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer CNDV-50MT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info