Bedienungsanleitung Pioneer RCS-606H-S (Seite 78 von 152) (Englisch)

573927

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

Recording

• EP (Extended Play) – Lower quality than LP, but gives

about six hours of recording time on a DVD disc.

• SLP (Super Long Play) – Lower quality than EP, but

gives about eight hours of recording time on a DVD

disc.

• SEP (Super Extended Play) – Lowest video quality but

gives about ten hours of recording time on a DVD

disc.

• MN1 to MN32 / LPCM

– Manual / Linear PCM

(available only when manual recording is on)

The setting is indicated in the front panel display, and

shown on-screen together with the recording time for a

blank recordable disc. If a recordable disc is loaded, the

approximate remaining recording time for that disc is

also shown. (Note that if the On Screen Display setting

(see On Screen Display on page 133) is Off then this

information is not displayed.)

Basic recording from the TV

Basic recording from the TV involves just setting the

channel to record, choosing whether to record to the

HDD or a DVD and selecting the recording quality.

1 Select the HDD or DVD for recording.

• If you’re recording to DVD, load a recordable disc (if

you load a new blank DVD-RW or DVD+RW disc, the

recorder takes a short while to initialize the disc).

• If you want to record a VR mode DVD-R or a Video

mode DVD-RW, you must initialize it before

proceeding (see Initializing recordable DVD discs on

page 85).

2 Select a TV channel to record.

The front panel display shows the channel number:

• While the recorder is stopped, you can also use the

number buttons on the remote to select the channel.

(For channel 24, press 2, 4 then ENTER)

• If the recorder is stopped, you can also use the CH +/

– buttons on the front panel to select the channel

number.

3 Set the picture quality/recording time.

• See Setting the picture quality/recording time above

for detailed instructions.

4 Select the audio channel to record.

See Changing audio channels on page 77 for more on

this.

• When recording in VR mode, if a broadcast is

bilingual, both audio channels are recorded, allowing

you to switch the audio channel on playback. The

only exception to this is when the picture quality is set

to LPCM, in which case you do need to select the

audio channel before recording.

5 Start recording.

If you want to set a recording end time, press the ì REC

button repeatedly. The recording time increases in 30

minute increments, up to a maximum of six hours. The

time the recording will end is shown on-screen and in the

front panel display. When the recording ends, the

recorder automatically switches into standby if no other

operation is being performed.

• To cancel the set recording time, press ì REC.

• If you want to pause recording at any time, press 

PAUSE. Press again to restart the recording. (If

recording to the HDD, DVD-RAM or in VR mode, a

new chapter is started after recording restarts)

6 Press to stop recording.

• If you set the recording time in the previous step, you

can still stop the recording anytime by pressing STOP

REC.

• Recording will stop automatically when there is no

more space on the HDD/DVD, or after 12 hours of

HDD recording (whichever is sooner).

If VPS/PDC is active for two timer programs that are

programmed to start at the same time, then the

program that actually starts first takes priority.

Tip

• During recording you can turn on/off the SCART loop

through function. During recording, press the front

panel CH + button to switch to SCART THRU (loop

through on), or CH – to switch to SCART NORM (loop

though off). Loop through is automatically reset to off

after recording has finished. Note that you can’t

switch loop through on if recording from the AV2/

(INPUT 1/DECODER) or AV1(RGB)-TV connectors.

Note

1.Audio is recorded in 16-bit Linear PCM format, video is recorded at XP quality. When recording a bilingual broadcast, select which audio chan-

nel to record (see Bilingual Recording on page 130).

DVD (VR) DVD (Video) DVD+R DVD+RW DVD-RAM HDD

HDD/DVD

ENTER

CHANNEL

–

Channel preset

REC MODE

AUDIO

MAIN SUB

REC

STOP REC



Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer RCS-606H-S Seite 78

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer RCS-606H-S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info