Bedienungsanleitung Pioneer SPH-DA130DAB (Seite 40 von 56) (Englisch)

699587

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

40En

*1 [All] is not available when [Network Mode] is selected as the speaker mode.

*2 If you change the listening position setting, the output levels of all the speakers will change in

conjunction with the setting.

*3 To use this function, the vehicle’s acoustics must be measured in advance.

*4 This function is not available when adjusting the High speaker.

*5 This function is available only when the listening position setting is set to [Front Left] or [Front

Right].

By measuring the vehicle’s acoustics, the equaliser curve can be adjusted automatically

to suit the vehicle interior.

WARNING

A loud tone (noise) may be emitted from the speakers when measuring the vehicle’s acoustics. Never

perform Auto EQ measurement while driving.

CAUTION

• Thoroughly check the conditions before performing Auto EQ as the speakers may be damaged if this

is performed under the following conditions:

– When the speakers are incorrectly connected. (For example, when a rear speaker is connected as a

subwoofer output.)

– When a speaker is connected to a power amp delivering output higher than the speaker’s

maximum input power capability.

• If a microphone for acoustical measurement (sold separately) is not placed in the appropriate

location, the measurement tone may become loud and measurement may take a long time, resulting

in battery drainage. Be sure to place the microphone in the specified location.

[Automatic Level Control] Corrects automatically the audio level difference between

the music files or the sources.

[Off] Turns the auto level control setting off.

[Mode1] Corrects a little the audio level difference between the

music files or the sources (for the narrow dynamic range

audio signal).

[Mode2] Corrects widely the audio level difference between the

music files or the sources (for the wide dynamic range

audio signal).

[Sound Retriever]

[Off] [Mode1] [Mode2]

Enhances compressed audio and restores rich sound

automatically.

TIP

[Mode2] has a stronger effect than [Mode1].

Adjusting the equaliser curve automatically (Auto EQ)

Menu Item Description

▶Before operating the Auto EQ function

• Perform Auto EQ in a quiet place with the vehicle engine and air conditioning

switched off. Also, cut the power of car phones or mobile phones in the vehicle, or

remove them in advance. Surrounding sounds may prevent correct measurement of

the vehicle’s acoustics.

• Be sure to use the microphone for acoustical measurement (sold separately). Using

other microphones may prevent measurement, or result in incorrect measurement of

the vehicle’s acoustics.

• To perform Auto EQ, the front speakers must be connected.

• When this product is connected to a power amp with input level control, Auto EQ may

be impossible if the power amp’s input level is set below the standard level.

• When this product is connected to a power amp with an LPF (low pass filter), turn the

LPF off before performing Auto EQ. Also, set the cutoff frequency for the built-in LPF of

an active subwoofer to the highest frequency.

• The distance has been calculated by a computer to provide optimum delay to ensure

accurate results. Do not change this value.

– The reflected sound within the vehicle is strong and delay occurs.

– The LPF on active subwoofers or external amps delay the lower sounds.

• If an error occurs during measurement, check the following before measuring the

vehicle’s acoustics.

– Front speakers (left/right)

– Rear speakers (left/right)

–Noise

– Microphone for acoustical measurement (sold separately)

– Low battery

▶Performing Auto EQ

CAUTION

Do not turn off the engine while the measurement is in progress.

NOTES

• Auto EQ changes the audio settings as follows:

– The fader/balance settings return to the centre position (page 38).

• Previous settings for Auto EQ will be overwritten.

Stop the vehicle in a quiet place, close all doors, windows, and sun roof, and then

turn the engine off.

If the engine is left running, engine noise may prevent correct Auto EQ.

NOTE

If driving restrictions are detected during measurement, the measurement is cancelled.

Fix the microphone for acoustical measurement (sold separately) in the centre of

the headrest of the driver’s seat, facing forwards.

The Auto EQ may differ depending on where you place the microphone. If desired,

place the microphone on the front passenger seat and perform Auto EQ.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer SPH-DA130DAB Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer SPH-DA130DAB

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info