574062
70
Zoom out
Zoom in
Vorherige Seite
1/104
Nächste Seite
Using other functions
08
70
En
Reducing the level of an analog
signal
The input attenuator lowers the input level of an analog
signal when it’s too strong. You can use this if you find
the that the OVER indicator is lights often, or you can
hear distortion in the sound.
From the remote control amplifier menu, press
INPUT ATT to switch the input attenuator on or off.
You may need to press on the Home menu ( )
first before reaching the amplifier menu screen shown
below (use the / (cursor left/right) soft keys to go to
the previous/next menu screen).
Note
The attenuator isn’t available with digital sources, or
when using Stream Direct modes 2 or 3.
Adjusting the delay of a soundtrack
Some monitors have a slight delay when showing video,
so the soundtrack will be slightly out of sync with the
picture. By adding a bit of delay, you can adjust the sound
to match the presentation of the video.
1 Press OPTION repeatedly until SOUND DELAY
shows in the display.
With the remote, you may need to press on the
Home menu ( ) first before reaching the amplifier
menu screen shown below (use the / (cursor left/
right) soft keys to go to the previous/next menu screen).
2 Use the (OPTION) +/– buttons to adjust the
amount of delay.
The delay can be adjusted from 0.0–6.0 frames (in 0.1
frame steps).
3 Press ENTER to confirm.
Note
When listening to an analog source, you can’t use
sound delay when Stream Direct is on.
One second is equal to 30 frames of NTSC format
video, and 25 frames of PAL.
Watching video and audio sources
independently
You can listen to a sound source and select a different
video source on your TV.
While listening to a source, press VIDEO SELECT
to select the video source you want to watch.
With the remote, you may need to press on the
Home menu ( ) first before reaching the amplifier
menu screen shown below (use the / (cursor left/
right) soft keys to go to the previous/next menu screen).
AMPLIFIER
AMPLIFIER
3/3
SB CH
MODE
INPUT
STATUS
INPUT
AT T
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
AMPLIFIER
TV
CONT
PHONES
SP SYSTEM
A/B
SIGNAL
SELECT
VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIOLR
MIDNIGHT
LOUDNESS OPTIONTONE DIGITAL NR INPUT ATT SELECT
CH LEVEL
ACOUSTIC
CAL.
AMPLIFIER
AMPLIFIER
2/3
AMPLIFIER
TV
CONT
MIDNIGHT DIGITAL NR
TONE LOUDNESS
OPTION
+
CH LEVEL
+
PHONES
SP SYSTEM
A/B
SIGNAL
SELECT
VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIOLR
MIDNIGHT
LOUDNESS OPTIONTONE DIGITAL NR INPUT ATT SELECT
CH LEVEL
ACOUSTIC
CAL.
AMPLIFIER
70

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Pioneer VSA-AX10i-S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Pioneer VSA-AX10i-S

Pioneer VSA-AX10i-S Bedienungsanleitung - Deutsch - 104 seiten

Pioneer VSA-AX10i-S Bedienungsanleitung - Englisch - 25 seiten

Pioneer VSA-AX10i-S Bedienungsanleitung - Holländisch - 104 seiten

Pioneer VSA-AX10i-S Bedienungsanleitung - Französisch - 104 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info