Bedienungsanleitung Pioneer VSX-30 (Seite 116 von 136) (Englisch)

574064

116

Zoom out

Zoom in

Vorherige Seite

1/136

Nächste Seite

Additional information12

116

Video

The maximum volume

available (shown in the front

panel display) is lower than

the +12dB maximum.

• Check that the Volume Limit is set to OFF (see Volume Setup on page 110).

• The channel level setting may be over 0dB.

Symptom Remedy

No image is output when an

input is selected.

• Check the video connections of the source component (see page 29).

• For HDMI, or when digital video conversion is set to OFF and a TV and another

component are connected with different cords (in Setting the Video options on

page 75), you must connect your TV to this receiver using the same type of video

cable as you used to connect your video component.

• Make sure the input assignment is correct for components connected using

component video or HDMI cables (see The Input Setup menu on page 44).

• Check the video output settings of the source component.

• Check that the video input you selected on your TV is correct.

• Some components (such as video game units) have resolutions that may not

be converted. If adjusting this receiver’s Resolution setting (in Setting the Video

options on page 75) and/or the resolution settings on your component or

display doesn’t work, try switching Digital Video Conversion (in Setting the Video

options on page 75) to OFF.

Can’t record video. • Check that the source is not copy-protected.

• The video converter is not available when making recordings. Check that the

same type of video cable is used for connecting both the recorder and the video

source (the one you want to record) to this receiver.

Noisy, intermittent, or

distorted picture.

• Sometimes a video deck may output a noisy video signal (during scanning,

for example), or the video quality may just be poor (with some video game units,

for example). The picture quality may also depend on the settings, etc. of your

display device. Switch off the video converter and reconnect the source and

display device using the same type of connection (component or composite),

then start playback again.

Video signals are not output

from the component

terminal.

• When a monitor only compatible with resolutions of 480i is connected to the

component terminal and another monitor is connected to the HDMI terminal,

the video signals may not be output to the monitor connected to the component

terminal. If this happens, do the following:

– Turn off the power of the monitor connected to the HDMI terminal.

– Change the VIDEO PARAMETER menu RES setting (page 75).

– Video signals from the HDMI terminal cannot be output to the component

terminals. Input the video signals from the player or other source to the

composite or component terminals. When using the component terminal,

assign it at Input Setup.

VSX-31_30_UC.book 116 ページ２０１０年８月２５日　水曜日　午前９時２８分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer VSX-30 Seite 116

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info