Bedienungsanleitung Polar CS 600X (Seite 59 von 70) (Englisch)

464060

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

If you have done some hard training in recent weeks and know that you can safely reach maximum heart

rate, you can safely take a test to determine your HR

max

yourself. Having a training buddy during the test

is recommended. If you are uncertain, consult your physician before undertaking the test.

Here is an example of a simple test.

Step 1: Warm up for 20 minutes on a flat surface, building up to your usual training pace.

Step 2: Choose a hill that will take more than 2 minutes to climb. Cycle up the hill once, building to as

hard a pace as you can hold for 20 minutes. Return to the base of the hill.

Step 3: Cycle up the hill again, building towards a pace you could just about hold for 10 minutes. Note

your highest heart rate. Your maximum is approximately 10 beats higher than the noted value.

Step 4: Cycle back down the hill, allowing your heart rate to drop 30-40 beats per minute.

Step 5: Cycle up the hill once again at a pace that you can only hold for 1 minute. Try to cycle halfway up

the hills. Note your highest heart rate. This brings you close to your maximum heart rate. Use this value as

your maximum heart rate to set training zones.

Step 6: Make sure you get a good cool-down, a minimum of 15 minutes.

Heart Rate Value in a Sitting Position

sit

is your average heart rate when completely still (i.e. while sitting). To easily determine HR

sit

, wear

your heart rate sensor, sit down, and do not engage in any physical activity. For a more precise

measurement, repeat the procedure several times and calculate your average.

Heart Rate Reserve

Heart rate reserve (HRR) is the difference between maximum heart rate (HR

max

), and resting heart rate

(HR

rest

)*. HRR is used to calculate exercise heart rates. It is the range within which heart rate varies

depending on exertion level. HRR equals oxygen uptake reserve (VO

R).

Exercise heart rate can be determined by using the Karvonen formula**. Add the given percentage of heart

rate reserve to resting heart rate.

Exercise HR = % of target intensity (HR

max

– HR

rest

) + HR

rest

Example:

Target intensity 70 % HRR for a person with HR

max

201 bpm and HR

rest

50 bpm

Exercise HR= 70% (201-50) + 50

Exercise HR=156 bpm

For a precise exercise heart rate, you need your exact HR

max

and HR

rest

. When using estimated HR

max

exercise heart rate values are always estimates.

*In Polar CS600X cycling computer, the heart rate value during a resting state is measured in a sitting

position (HR

sit

). This is for practical reasons since HR

sit

is used in energy expenditure calculation because

of accuracy. HR

sit

matches the low intensity to which different exercise intensities can be compared.

**Karvonen M, Kentala K, Mustala O. The effects of training on heart rate: a longitudinal study. Ann Med

Exp Biol Fenn 1957; 35: 307-315.

Heart Rate Variability

Heart rate varies with every heartbeat. Heart rate variability (HRV) is the variation of beat-to-beat intervals,

also known as R-R intervals.

ENGLISH

Backround Information 59

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polar CS 600X Seite 59

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polar CS 600X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info