Bedienungsanleitung Polar M91ti (Seite 25 von 33) (Englisch)

460170

Zoom out

Zoom in

Vorherige Seite

1/33

Nächste Seite

CROSSTALK

The Polar wrist receiver in non-coded mode of operation

picks up transmitter signals within 1 metre/3 feet. Non-

coded signals from more than one transmitter picked up

simultaneously can cause an incorrect readout.

EXERCISE EQUIPMENT

Several pieces of exercise equipment with electronic or

electrical components such as LED displays, motors and

electrical brakes may cause interfering stray signals. To try

to tackle these problems, relocate the Polar wrist receiver

as follows:

1. Remove the transmitter from your chest and use the

exercise equipment as you would normally.

2. Move the wrist receiver around until you find an area in

which it displays no stray reading or flashing of the heart

symbol. Interference is often worst right in front of the

display panel of the equipment, while the left or right

side of the display is relatively free of disturbance.

3. Put the transmitter back on the chest and keep the wrist

receiver in this interference-free area as far as it is

possible.

4. If the Polar heart rate monitor still does not work with

the exercise equipment, this piece of equipment may be

electrically too noisy for wireless heart rate measurement.

MINIMISING POSSIBLE RISKS IN

EXERCISING WITH A HEART RATE

MONITOR

Exercise may include some risk, especially for those who

have been sedentary. To minimise possible risks consider

the following advice:

Before beginning a regular exercise program consult

your doctor

• if you are over 40 years of age and have not been

following a regular exercise program during the past 5

years

PRECAUTIONS

USING A POLAR HEART RATE

MONITOR IN A WATER

ENVIRONMENT

Your Polar heart rate monitor is water resistant to 100

metres/ 330 feet. To maintain the water resistance, do not

operate the buttons of the wrist receiver under water.

Heart rate measurement in a water environment is

technically demanding for the following reasons:

• Pool water with a high chlorine content and seawater

may be very conductive and the electrodes of Polar

transmitter may get short circuited and ECG signals

cannot be detected by the transmitter unit.

• Jumping into the water or strenuous muscle movement

during competitive swimming may cause water resistance

that shifts the transmitter on the body to a location

where it is not possible to pick up ECG signal.

• The ECG signal strength varies depending on the

individual’s tissue composition and the percentage of

people who have problems in heart rate measuring is

considerably higher in a water environment than in other

use.

POLAR HEART RATE MONITOR

AND ELECTROMAGNETIC

INTERFERENCE

Disturbances may occur near high voltage power lines,

traffic lights, overhead lines of electric railways, electric bus

lines or trams, televisions, car motors, bike computers, some

motor driven exercise equipment, cellular phones or when

you walk through electric security gates.

man M91ti GBR B 14.1.2001, 01:1046-47

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polar M91ti Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polar M91ti

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info