Bedienungsanleitung Polar RC3 GPS (Seite 50 von 60) (Englisch)

542762

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

12. IMPORTANT INFORMATION

Caring for Your Product

Like any electronic device, the Polar training computer should be treated with care. The suggestions below

will help you fulfil guarantee obligations and enjoy this product for many years to come.

Training computer

Keep your training computer clean. Use a damp paper towel to wipe dirt from the training computer. To

maintain the water resistance, do not wash the training computer with a pressure washer. Do not immerse

the training computer in water. Never use alcohol or any abrasive material such as steel wool or cleaning

chemicals.

After each time of using the USB port of the training computer, check visually that there is no hair, dust

or other dirt on the sealing surface area of the lid/back case. Gently wipe to remove any dirt. Do not use

any sharp tools or equipment for cleaning, which could cause scratches to the plastic parts.

Not suitable for bathing or swimming. Protected against wash splashes and raindrops. Do not immerse the

training computer in water. Using the training computer in excessive rainfall may cause interference on GPS

reception.

Operating temperatures are -10 °C to +50 °C / +14 °F to +122 °F.

If you use the RC3 GPS unit in extreme conditions (high humidity and big temperature changes), some

water might condensate inside the unit. This does not damage the unit and water will evaporate after a

while. If you want to speed up the evaporation, open the USB lid to ventilate the unit. Please remember to

close the USB lid properly afterwards to secure waterproofness.

Heart rate sensor

Connector: Detach the connector from the strap after every use and dry the connector with a soft towel.

Clean the connector with a mild soap and water solution when needed. Never use alcohol or any abrasive

material (eg. steel wool or cleaning chemicals).

Strap: Rinse the strap under running water after every use and hang to dry. Clean the strap gently with a

mild soap and water solution when needed. Do not use moisturizing soaps, because they can leave residue

on the strap. Do not soak, iron, dry clean or bleach the strap. Do not stretch the strap or bend the

electrode areas sharply.

Check the washing instructions on the label of the strap.

CS speed sensor, CS cadence sensor and s3+ stride sensor

Clean the sensors with a mild soap and water solution and rinse them with clean water. To maintain the

water resistance, do not wash the sensors with a pressure washer. Do not immerse the CS speed sensor,

CS cadence sensor or s3+ stride sensor in water. Never use alcohol or any abrasive material such as steel

wool or cleaning chemicals.

Avoid hard hits to the sensors, as these may damage the sensor units.

Storing

ENGLISH

50 Important Information

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polar RC3 GPS Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polar RC3 GPS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info