Bedienungsanleitung Polar RC3 GPS (Seite 52 von 60) (Englisch)

542762

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Polar Service Centers. In the USA the sealing ring/battery kits are also available at www.shoppolar.com.

When handling a new, fully charged battery, avoid clasp-like contact, i.e. simultaneously from both sides,

with metal or electrically conducting tools, like tweezers. This may short circuit the battery, causing it to

discharge more rapidly. Typically, short circuiting does not damage the battery, but it may decrease the

capacity and the lifetime of the battery.

Changing Heart Rate Sensor Battery

1. Lever the battery cover open by using the clip on

the strap.

2. Insert the battery inside the cover with the

negative (-) side outwards. Make sure the sealing

ring is in the groove to ensure water resistance.

3. Align the ledge on the battery cover with the slot

on the connector and press the battery cover

back into place. You should hear a snap.

Danger of explosion if the battery is replaced with wrong type.

Precautions

The Polar RC3 GPS training computer shows your performance indicators. The training computer is

designed to indicate the level of physiological strain and recovery during and after an exercise session. It

measures heart rate, speed and distance. It also measures running cadence when used with s3+ stride

sensor and cycling cadence when used with a CS cadence sensor W.I.N.D.. No other use is intended or

implied.

The training computer should not be used for obtaining environmental measurements that require

professional or industrial precision.

Interference During Training

Electromagnetic Interference and Training Equipment

Disturbance may occur near electrical devices. Also WLAN base stations may cause interference when

training with the training computer. To avoid erratic reading or misbehavior, move away from possible

sources of disturbance.

Training equipment with electronic or electrical components such as LED displays, motors and electrical

brakes may cause interfering stray signals. To solve these problems, try the following:

1. Remove the heart rate sensor strap from your chest and use the training equipment as you would

normally.

2. Move the training computer around until you find an area in which it displays no stray reading or does not

flash the heart symbol. Interference is often worst directly in front of the display panel of the equipment,

while the left or right side of the display is relatively free of disturbance.

3. Put the heart rate sensor strap back on your chest and keep the training computer in this

interference-free area as much as possible.

If the training computer still does not work with the training equipment, it may be electrically too noisy for

wireless heart rate measurement. For further information, see www.polar.com/support

[http://www.polar.com/support].

Parts of RC3 GPS are magnetic. It may attract metallic materials and it's magnetic field may interfere with

a compass. To avoid interference, it is recommended to wear your compass on one arm (at the level of

your chest) and your RC3 GPS on the other arm's wrist. Do not place credit cards or other magnetic

ENGLISH

52 Important Information

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polar RC3 GPS Seite 52

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polar RC3 GPS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info