Bedienungsanleitung Polti Vaporetto Lecoaspira FAV80 Turbo Intelligence (Seite 11 von 21) (Englisch)

648713

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

2. CONNECTION OF ACCESSORIES (see page 4)

All the Vaporetto Lecoaspira accessories can be connected

directly to the flexible steam/vacuum hose or to the extension

hoses.

2.1 To connect the specific accessories for the suction and

steaming features proceed as follows:

Move the locknut of the accessory, if

present, to the OPEN position and connect

the accessories.

Move the accessory locknut to the CLOSED

position. Check the strength of the

connection.

On the extension tubes there is an

additional fastening button: proceed as

described previously for the accessories

and release the tubes by sliding the button

as far as the lock position.

2.2 To connect the special accessories only for suction it is only

necessary to attach them without coupling them to the locknut.

2.3 To connect the steam lance with the steam concentrator,

simply screw it on. The same operation can be carried out for the

coloured brushes, which can in turn be screwed onto the steam

concentrator and onto the steam lance. The different colours

allow you to always use the same brush for the same surface.

3. INTEGRATED CLEANING PROGRAMS

The appliance is equipped with preset programmes to

automatically regulate the steam pressure and the duration of

suction based on the surface in question.

3.1 Press the SET button on the control panel. When it is turned

on, the appliance starts in manual mode. Using the buttons

and it is possible to select the desired programme. Confirm

the selection by pressing the OK button.

To change the programme again, repeat the operation indicated

above.

4. MANUAL OPERATION

In this mode, it is possible to manually adjust the quantity of

steam dispensed and the suction speed.

Make sure that you have prepared the appliance following the

instructions provided in Chapter 1.

4.1 For suction only, press the suction button on the appliance

and proceed with cleaning.

The suction power can be adjusted, based on the surface to be

cleaned, by holding the suction button down. In this case the

number of segments on the suction indicators will increase or

decrease on the appliance control panel.

Hold the suction button down to stop suction.

4.2 For steam cleaning only, switch on the boiler using the

button . The pressure and boiler indicators will start flashing.

Select the steam pressure desired by pressing the button

again. One of the 4 pressure indicators lights up every time the

button is pressed, indicating the increase in the pressure of the

steam. Press the button to reduce the steam pressure. One of

the pressure indicators goes off every time the button is

pressed, showing the reduction in the steam pressure.

When the pressure indicator and the boiler indicator remain lit,

it means that the appliance has reached the desired steam

pressure.

Ensure that the steam lock on the handle is deactivated. Hold

the steam trigger to dispense steam, the relative indicator will

turn on.

To stop the steam flow, simply release the steam button.

4.3 For steam cleaning and suction, carry out points 4.1 and 4.2

at the same time.

Steam

Maximum

4 indicators

turned on

To remove scaling, stains, and

grease and sanitise

Regular

steam

2 or 3 indicators

turned on

For carpets, rugs, windows,

floors

Minimum

steam

1 indicator

turned on

To steam plants, clean delicate

fabrics, wall coverings, sofas, etc.

FAV70

FAV80

On the appliance, under the handle, there is a handy label

listing the number and type of programmes.

WARNING: The preset programmes can vary depending on

the Lecoaspira model chosen.

To avoid any dirt in the dirt collector causing bad smells, we

recommend emptying and cleaning after every use according

to the methods described in Chapter 22.

For safety reasons, engage the steam lock on the handle

during vacuuming.

Level 1 Curtains

Level 2 Sofas and cushions

Level 3 Rugs and carpets

Level 4 Floor or liquid collection

When the appliance is switched on again, the suction level will

be that set last time it was used.

| 28|

ENGLISH

PRELIMINARE LECOASPIRA FAV70_80 - 2015_vers7:UNICO 04/05/2015 17.28 Pagina 28

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polti Vaporetto Lecoaspira FAV80 Turbo Intelligence Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polti Vaporetto Lecoaspira FAV80 Turbo Intelligence

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info