POWDP7040 EN
Copyright © 2019 VARO P a g e | 7 www.varo.com
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
7.2 Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the machine is switched
off or remove the battery pack.
▪ Hold the tool with one hand and the battery pack with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
7.3 Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (A) Before using the machine, please press switch trigger
to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are lit: Battery fully charged
2 LED’s are lit: Battery 60% charged
1 LED is lit: Battery almost discharged
8 FEATURES
8.1 Display readings
▪ Low voltage protection display (Fig. 4) (recharge battery pack)
▪ Boot display (Fig. 5) (machine is starting up)
▪ Over-temperature protection display (Fig. 6) (device/battery needs to cool down)
▪ Overcurrent protection: this symbol is displayed to protect the machine from short circuit or
damage. This may occur when you use the machine for a long continuous period of time.
When the machine doesn’t function anymore, shut down and restart after a few
minutes.(Fig. 14)
8.2 Flash light (Fig. 7)
If you need flash light, please press the LED light button.
8.3 Unit change (Fig. 8)
The inflator has three units: psi/bar/kpa, you can press the button to switch between these
units.
