POWDP7060 EN
Copyright © 2021 VARO P a g e | 6 www.varo.com
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool
down to room temperature before charging. This will extend the life of your
batteries.
7.2 Removal / insertion of battery (Fig. 2)
Battery tools are always in operating condition. Place the switch in the off
position and remove the battery pack when the product is not in use or
when carrying at your side.
▪ Hold the tool with one hand and the battery pack (11) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
7.3 Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (13). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are lit: Battery fully charged
2 LED’s are lit: Battery 60% charged
1 LED is lit: Battery almost discharged
8 OPERATION
8.1 Starting the soldering iron (Fig.4)
▪ Make sure the battery is charged.
▪ Set the power switch (4) in the on position (I).
▪ The battery level indicator led (3) light will turn green. This indicator is part of the power
switch and is a bead surrounding the switch. When the battery is depleted the indicator (3)
will turn red.
▪ The heating indicator led (6) will turn red and burn continuously until the iron is hot enough
to start working.
▪ Set the temperature (°C) adjustment knob (5) to the desired level depending on the
application.
▪ The heating indicator led (6) will flash until the set temperature is reached, at that point the
led will go out.
▪ When during operation the temperature has dropped, warming will start again (led flashes)
until the set temperature is reached (led goes out).
