POWE40040 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
8.3 Variable speed control
The operator can adjust variable speed by turning the speed adjustment dial (9), It is the
highest speed in the “6” position, gradually slow down, lowest speed in the “1” position.
9 OPERATION
▪ Check that the right type of sanding belt is fitted.
▪ Hold the sander with one hand on the handle (2) and the other on the auxiliary handle (3).
Switch on by pressing the ON/OFF switch trigger (10). Apply the sander to the work piece.
Sand lengthways along the work piece.
▪ Give the sander time to work. It is rarely necessary to press the sanding belt hard against
the surface to be worked. Start with coarse sandpaper and switch to finer paper if/when
required. If a very smooth surface is required, clean the item thoroughly with a soft cloth
after the final sanding. Switch to very fine sandpaper and give the item one extra sanding.
▪ Avoid blocking the vent holes with your hand, as this may cause the sander to overheat.
▪ Switch off by releasing the ON/OFF switch trigger.
9.1 Surrounding Conditions
The power tool is designed for 230 Volt alternating current voltage with a power frequency of
50 Hz. Check whether the extension cord is undamaged and is correctly connected to the
electrical socket of the power grid and the power plug of the power tool. Your professional
advisor will be happy to inform you about the selection of the correct extension cord.
10 MAINTENANCE AND CARE
Please Note! Always pull out the power plug before cleaning!
Make sure that the ventilation slots are free in order to avoid overheating and the damage to
the machine connected with it. Despite this, should the machine overheat, switch it off for
several minutes for cooling. Do not use any solvents for cleaning the plastic parts. Various
chemicals can corrode and damage the parts. Use only clean cloths for the removal of dirt, oil,
grease and dust etc. In the event of excessive sparking, check the carbon brushes. Make sure
that no fluids enter the machine. Only have the replacement of the electrical cord performed
by an electrical specialist. In order to be able to make optimal use of the belt sander, always
use original accessories, which are available at every specialty store.
11 TECHNICAL DETAILS
