POWEG2030 EN
Copyright © 2022 VARO P a g e | 10 www.varo.com
9.2 Mixing fuel
Add oil to an approved fuel container followed by the gasoline to allow incoming gasoline to
mix with oil. Shake container to ensure thorough mix.
Warning: Lack of lubrication voids engine warranty. Gasoline and oil must
be mixed at 40:1
9.2.1 Fuel and lubrication symbols
9.2.2 Mixing ratio: 40 parts gasoline to 1 part lubricant
9.2.3 Recommended fuels
Some standard petrols are enriched with oxygen-containing compounds such as alcohol or
ether to comply with regulations on clean air. The motor is designed to work well on any car
petrol, including these enriched petrols, on the condition that the above mixing ratios are
observed!
9.2.4 Chain and bar lubrication
Always refill the chain oil tank each time the fuel tank is refilled. We recommend using our
replacement chain & bar. Always use good quality chain oil, which contains additives to
reduce friction and wear and to assist in the prevention of pitch formation on the bar and chain
10 OPERATION
10.1 Engine pre start checks (Fig 9)
WARNING: Never start or operate the saw unless the bar and chain are
properly installed.
▪ Fill the fuel tank (A) with correct fuel mixture.
▪ Fill the oil tank (B) with correct chain and bar oil...
10.2 Starting a cold engine
▪ Activate the chain brake (move the hand guard forward and engage it) (Fig. 10a).
▪ To start the saw, push the switch (ON/OFF switch) to the ON (I) position. (Fig. 10b)
▪ Pull out the choke (A) to the point where it latches in place. (Fig. 10c)
▪ Press primer bulb 3 to 5 times.
▪ Place the saw on a firm and level surface. Hold the saw securely with your foot as
illustrated. Tug sharply on the starter several times until first firing sound is heard. (Fig.
10d)
