POWEG2030 EN
Copyright © 2022 VARO P a g e | 11 www.varo.com
▪ Choke will be turned off automatically when you pull the throttle. (Fig. 10e)
▪ Forcefully pull the starter until the motor engages. (Fig 10f)
▪ Slightly press in the throttle (Fig 10g)
▪ Pull back the brake lever to release the chain brake (Fig 10h)
10.3 Warm start
▪ Activate the chain brake (Fig 10i)
▪ Set the switch (on/off) to ON(I) position (Fig 10j)
▪ Forcefully pull the starter until the motor engages (Fig 10k)
▪ Slightly press down on the throttle (Fig 10l)
▪ Release the chain brake (Fig 10m)
10.4 When engine is saturated with fuel
▪ Remove the air filter
▪ Remove the spark plug
▪ Position the machine in an angle of 45° with the sword upwards
▪ Pull the starters rope a few times
▪ Clean the spark plug and place back
▪ Place back the air filter and start without choke
10.5 To stop engine (Fig 10n)
▪ Release the throttle and allow engine to return to idle speed.
▪ Push the I/O (on/off) switch to O (off) to stop engine.
Note: for emergency stopping, simply activate chain brake and switch the
I/O (on/off) switch to o (off).
10.6 Chain brake operational test
Test the chain brake periodically to ensure proper function.
Perform a chain brake test prior to initial cutting, following extensive cutting, and definitely
following any chain brake service.
Test chain brake as follows:
▪ Place saw on a clear, firm, flat surface.
▪ Start engine.
▪ Grasp the rear handle (9) with your right hand (fig. 11).
▪ With your left hand, hold the front handle (4) (C)] firmly (fig. 11).
▪ Squeeze the throttle trigger to 1/3 throttle, then immediately activate the chain brake lever
(3) (fig. 11).
Warning: activate the chain brake slowly and deliberately. Keep the chain
from touching anything; don t let the saw tip forward.
▪ Chain should stop abruptly. When it does, immediately release the throttle trigger.
Warning: if chain does not stop, turn engine off and take your unit to the
nearest authorized service center for service.
▪ If chain brake functions properly, turn the engine off and return the chain brake to the
disengaged position.
