POWEG63732 EN
Copyright © 2022 VARO P a g e | 12 www.varo.com
9.7 Mowing tips
▪ Under certain conditions, such as very tall grass, it may be necessary to raise the cutting
height to reduce resistance (prevent overload of the engine) and leaving clumps of grass
clippings. It may also be necessary to run the lawn mower over the area a second time.
▪ For extremely heavy cutting, reduce the width of cut by over lapping previously cut paths
and mow slowly.
▪ The pores in the cloth grass catcher can become blocked with dirt and dust and will collect
less grass. To prevent this, regularly hose down the grass catcher and let dry before re
using.
▪ Keep the top of the engine (around the starter) clear and clean of grass clippings and
chaff. This will help engine air flow and extend engine life.
▪ Walk, never run with the mower. Be very careful when mowing uneven or rough ground.
▪ Mow across slopes, never up and down.
▪ Be careful when changing the direction of the mower on a slope.
▪ Do not mow excessively steep slopes.
▪ The best result will be achieved if the grass id dry. Wet grass will tend to clog the blade
and the grass collection system.
▪ Grass grows at different rates at different time of the year. Never use the lowest cutting
height for the first cut of the season or in drought conditions.
▪ Only about one thirds of the grass height should be cut.
▪ When mowing with mulching, to ensure that the cut grass can be scattered efficiently, do
not cut high or wet grass. When you have been cutting for several minutes, please stop
the mower and clean the blade and the deck.
▪ Do not remove grass debris in the mower casing or on the blade by hand or with your feet.
Instead use suitable tools such as a brush or broom.
10 FUNCTIONS
These lawn mowers can be retrofitted from its normal function, based on the application
purpose:
▪ For normal mowing fit the grass bag.
▪ For rear discharging remove the grass bag.
11 MAINTENANCE
IMPORTANT - Regular, careful maintenance is essential for keeping the
safety level and original performance of the machine unchanged in time.
Stop the engine and disconnect and earth the spark plug before any
repairing or maintenance operations.
Warning! Risk of injury due to dangerous moving parts!
Complicated operations – not listed here below – must be carried out by a
specialized technical assistance centre.
The replacement of the cutting device should be done by a qualified
specialist! Rework or sharpening blades is not recommended unless it is
done by a repair service or a similarly qualified specialist!
