POWPB40400 EN
Copyright © 2020 VARO P a g e | 7 www.varo.com
8 CHARGING AND INSERTION OR REMOVAL OF BATTERY
8.1 Charger indications (Fig. 1)
Connect the charger to the power outlet socket
▪ Steady red light: charger has been plugged in
▪ Steady red light and flashing green light: battery is charging
▪ Steady red light and steady green light: battery is completely charged
▪ Flashing red light: battery pack is too hot. Let the battery pack cool down for approximately
30 minutes before attempting to recharge.
▪ Red light and green light flashing alternatively: battery pack is defective and needs to be
replaced.
▪ NOTE: if you are getting a “defective” indication, remove and reinstall the battery in the
charger. If the lights status still shows defective, try charging a different battery. If a
different battery charges normally, dispose of the defective battery. If a different battery
also indicates “defective” the charger may be defective.
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
8.2 Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the machine is switched
off or remove the battery pack.
▪ Hold the tool with one hand and the battery pack (8) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3 Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (10). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged
2 LED’s are litt: Battery 60% charged
1 LED is litt: Battery almost discharged
