POWX075730S EN
Copyright © 2022 VARO P a g e | 10 www.varo.com
9.6 Vertical bevel angle
The vertical bevel angle can be set in the rang of 0° to 45°. The vertical bevel scale shows the
currently set in degrees.
▪ Loosen the locking lever (20), if tightened.
▪ Swing the tool arm with the handle to the required angle.
▪ Tighten the locking lever (20).
▪ Place a protractor at the side of the saw blade and table, if the angle is not 45° bevel
angle. Adjusting the height of the adjustment screw until the bevel angle is the correct
angle. Finally tighten the nut and check the angle once more.
9.7 Slide lock adjustment
▪ To unlock and lock the slide bar (13), turn the slide bar lock knob (21) counterclockwise or
clockwise
For long workpieces you should use the slide; loosen the locking knob for this purpose.
▪ Saw trough the work piece.
▪ Switch off the power tool.
▪ Wait until the saw blade (2) has come to a complete standstill before removing the work
piece.
9.8 Depth stop (Fig. 4)
When not a complete cut through the work piece is desired, use the depth stop bolt (31) to
control the depth of cut.
Only adjust the front bolt. The rear bolt is used to prevent the blade from
cutting the table during normal cutting. Do not adjust the rear bolt.
▪ Unlock the retaining pin.
▪ Raise the saw head assembly.
▪ Push the depth stop to the left to use the depth stop bolt settings.
▪ Pull down on the saw head to check the current setting.
▪ To change the setting, first loosen the knurled depth stop nut on the depth stop bolt. Turn
the depth stop bolt clockwise to decrease depth and counterclockwise to increase depth.
Tighten the depth stop nut after adjustment.
▪ If needed, push the depth stop to the right to temporarily disable it.
9.9 Switching ON / OFF
For your safety use both hands to switch the power tool on and off.
▪ Connect the power tool to the power supply.
▪ Hold the operating handle (14) firmly and move the lock-off lever (16) to the left meanwhile
squeeze the switch trigger (15). Allow the blade to reach maximum speed and slowly
lower the blade into and through the workpiece. The saw blade rotates as long as you
keep the switch engaged.
▪ When you want to turn off the machine, you have to release the on/off switch (15).
9.10 Laser
▪ You can switch the laser ON and OFF with the switch (12)
▪ The laser (23) directs a beam onto the workpiece
▪ Extremely precise cuts can be made using the laser function.
9.11 Dust bag
To attach the dust bag (18), fit it onto the dust extraction adapter. When the dust bag is about
half full, remove the dust bag from the tool and empty it.
