POWX075751DB EN
Copyright © 2022 VARO P a g e | 10 www.varo.com
9.6 Bevel cut 0°- 45° and mitre cut 0° - 45° (machine head at 0° - 45° and turntable 0°-
45°) (Fig. 1, 2, 6, 9)
Remark: The saw can be used to make bevel cuts to the left and right of 0°-
45° in relation to the work face, and at the same time 0° - 45° to the left or 0°
- 45° to the right in relation to the back fence(double mitre cut).
▪ Important. To make miter cuts (inclined saw head), the back fence(28) must be fixed at the
outer position.
▪ Loosen the lock screw for back fence (29) for the back fence(28) and push the back fence
outwards.
▪ The back fence(28) must be fixed far enough away of the innermost position that the
distance between the back fence(28) and the saw blade (7) amounts to a maximum of 5
mm.
▪ Before making a cut, check that the back fence(28) and the saw blade (7) cannot collide.
▪ Secure the lock screw for back fence (29) again, move the machine head (5) to its upper
position.
▪ Release the turntable (16) by loosening the handle (13) and pulling the indexed position
lever (12) up.
▪ Using the turntable handle (13), set the turntable (16) to the desired angle.
▪ Re-tighten the turntable handle (13) in order to secure the turntable.
▪ Undo the locking screw (22-Fig.5) and use the handle (1) to tilt the machine head (5) to
the left or the right top the required angle.
▪ Re-tighten the lock screw (22).
▪ Make the cut as described above.
9.7 Limiting the cutting depth (Fig. 3)
The cutting depth can be infinitely adjusted using the screw for cutting depth limiter (26). To do
this loosen the knurled nut on the screw for cutting depth limiter (26). Turn the screw for
cutting depth limiter (26) in or out to set the required cutting depth. Then re-tighten the knurled
nut on the screw for cutting depth limiter (26). Check the setting by completing a test cut.
9.8 Sawdust bag (Fig. 2)
The saw is equipped with a sawdust bag (21) for sawdust and chips. Squeeze together the
metal ring on the dust bag and attach it to the outlet opening in the motor area. The sawdust
bag (21) can be emptied by means of a zipper at the bottom.
Alternatively a specialized vacuum cleaner can also be used, possibly using an adapter.
9.9 Changing the saw blade (Fig. 10,11,12 and 13)
Important: Remove the power plug! Wear safety gloves when changing the
saw blade. Risk of injury!
▪ Swing up the machine head (5).
▪ Loosen the screw (f) of the flange cover so that it is free to move.
▪ Swing up the moveable blade guard (6) to the point where the recess in the moveable
blade guard (6) is above the flange screw (32).
▪ Insert the hexagonal key (c) in the flange screw (32).
▪ Firmly press the saw shaft lock (4) and slowly rotate the flange screw (32) in clockwise
direction.
▪ The saw shaft lock (4) engages after no more than one rotation.
▪ Now, using a little more force, slacken the flange screw (32) in the clockwise direction.
▪ Turn the flange bolt (32) right out and remove the outer flange (33).
