POWX07590 EN
Copyright © 2023 VARO P a g e | 9 www.varo.com
8.5 Mounting the saw blade guard
Risk of injury! The saw blade must be at least set to 30mm height.
▪ First, mount the crank (2).
▪ Put the blade in the highest position.
▪ Position the saw blade protection on the cleaving wedge (8) so that bolt engages in the
hole. Then attach the wing nut.
8.6 Mounting the tool stand
▪ Install one rubber feet (16) onto each leg .
▪ Insert the carriage bolts through the legs, through the braces and then into the holes.
Fasten each with a washer and hex nut. Tighten the nut.
▪ Assemble 2 fall prevention support (15) with the bolts, washes and nuts, and ensure them
firmly.
9 OPERATION
Risk of injury! In the event of a functional fault, immediately press the red
button 0 on the On / Off switch and unplug.
9.1 Check before starting the device!
Risk of injury! The device may only be put into operation if there are no
defects. If a part is defective danger it must be replaced before the device is
used again.
Check to make sure the device is in safe operating condition:
▪ Check to make sure there are no visible defects.
▪ Check to make sure all device components are correctly mounted.
▪ Check to make sure the safety equipment is functioning properly.
▪ Check to make sure that the saw blade runs freely.
▪ Check whether the adjusting screw for setting the angle of tilt is tightened.
9.2 Operating elements
9.2.1 On/off switch
▪ Switching on: Pressing the green button I on the On / Off switch (1) switches on the saw.
Before starting to saw, wait until the blade has reached maximum speed.
▪ Switching off: Pressing the red button 0 on the On / Off switch (1) switches off the saw.
9.2.2 Overload Protection (17)
The machine is fitted with an overload protection (17). Allow the machine to cool down for at
least 30 minutes before switching it on again. For this first press the black button next to the
switch, then press the green button (1) to restart the machine.
9.2.3 Setting mechanism for the tilt angle
The saw blade can be adjusted to any angle between 0° and 45°. Loosen the locking knob (3),
press the lever (2) and turn to the desired tilt angle and tighten the locking knob (3).
