POWX3240 EN
Copyright © 2022 VARO P a g e | 6 www.varo.com
7 ASSEMBLY
7.1 Fitting and removing the motor housing
▪ Note: mount the additional handle (14) first before fitting the motor housing (3) to avoid
interference between components.
▪ The motor housing has been locked to the tub with clamps.
▪ To remove the motor housing (3). first unlock the clamps (5) and then lift it from the tub
(6).
▪ To re-fit the motor housing, place it on the tub and tighten the clamps.
7.2 Mounting the wheels
▪ Remove the motor housing (3).
▪ Turn the tub (6) upside down and insert the wheels (8) in the openings.
▪ Turn the tub in its original position again.
▪ Re-fit the motor housing.
7.3 Mounting the hose
▪ Insert the hose (9) in the connection (7) and turn to lock.
7.4 Fitting the advanced filter (Fig. 1)
The advanced filter is suitable for collecting small waste material and dust.
▪ Remove the motor housing (3).
▪ Place the new advanced dust filter at the underside of the motor housing.
▪ Push to lock filter.
▪ Re-fit the motor housing.
7.5 Fitting a dust bag (Fig. 2)
A dust bag is suitable for collecting small waste material and dust.
▪ Remove the motor housing (3).
▪ Place a dust bag on the connection (7). Make sure to slide the opening past the raised
edge.
▪ Re-fit the motor housing.
7.6 Mounting the tube to the hose
▪ Slide the tube on the handgrip.
▪ Place the required nozzle on the tail end of the tube.
7.7 Connecting an electrical tool (Fig. 3)
The machine has been equipped with an electronic outlet for connection of your electrical
equipment. The machine is switched on automatically the moment you switch on the electrical
tool.
▪ Connect the hose (9) directly to the dust extraction outlet of the electrical tool.
▪ Insert the mains plug of the electrical tool into the outlet (2).
▪ Press ‘I’: The vacuum cleaner will start immediately.
▪ Press ‘II’: Start power tool on power socket, the vacuum cleaner will start after 3-4
seconds. Stop the tool, the vacuum cleaner will stop after 8 seconds.
▪ Press ‘0’: Vacuum cleaner stop, but tool can work without vacuum cleaner
8 OPERATION
Make sure the power cord has been fully unwound before you switch on the machine. The air
leaving the grids must not be hindered.
If the electrical tool has been connected to the electronic outlet, directly switch on the electrical
equipment.
Use the crevice nozzle for vacuuming up dust from narrow and confined spaces.
When vacuuming up liquids, make sure the nozzle is not fully submerged in the liquid to be
vacuumed up.
