POWX3240 EN
Copyright © 2022 VARO P a g e | 7 www.varo.com
Clean the machine after use according to instructions and wind the power cord around the
shell.
8.1 Switching on and off
▪ To switch on the machine, set the on/off switch (1) to “I”.
▪ To switch the machine off, set the on/off switch (1) to “O” / “=”.
8.2 Vacuuming up coarse waste material
▪ Check whether the new advanced dust filter has been fitted.
▪ Mount the tube (11) to the hose (9).
8.3 Vacuuming up small waste material and dust
▪ Check whether the new advanced dust filter has been fitted.
▪ Fit a dust bag.
▪ Mount the tube (11) to the hose (9).
8.4 Vacuuming up dust released from an electrical tool
▪ Check whether the new advanced dust filter has been fitted.
▪ Fit a dust bag
▪ Connect the hose (9) directly to the dust extraction outlet of the electrical tool.
8.5 Emptying the tub
▪ Switch off and unplug the machine.
▪ Remove the motor housing (3).
▪ Empty the tub (6).
8.6 Vacuuming up liquids (Fig 3a)
▪ Check whether the new advanced dust filter and dust bag has been removed.
▪ The sponge filter (17) must be used for vacuuming liquids.
▪ Install the sponge filter (17)
▪ Make sure the inside of the tub (6) is clean and free from dust.
▪ Mount the tube (11) to the hose (9) and fit the wet & dry floor brush.
8.7 Drain function (Fig. 4)
▪ When your tank is full of water, just twist the cover of the drain function to let the water out.
8.8 Blow function (Fig. 5)
▪ Remove dust cover and insert the hose connector into the blowing mouth to use the
blowing function.
9 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
Do not submerge the motor housing in water!
