POWXG50100 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
▪ To remove the attachment, turn the knob counter clockwise to loosen the coupler.
▪ Press the release button.
▪ Pull the attachment straight out of the coupler.
▪ To install and adjust the auxiliary handle (11):
▪ There are 3 positions in which the auxiliary handle can be fixed with 4 screws. Select the
suitable position according to the height of the operator. (Fig. 4)
▪ Screw the auxiliary handle and holder into position using the screws provided.
▪ Tighten the 4 screws until the auxiliary handle is secure.
▪ The harness, with quick-release function, can be installed to the harness hook behind the
rear handle. (Fig. 5)
8 PRE OPERATION CHECKS
WARNING! This machine is shipped without oil and fuel. You MUST ensure
all fluid levels are correct before operation otherwise you may cause serious
engine damage that will not be covered by the warranty.
WARNING! ALWAYS use a semi-synthetic 4 stroke SAE 10W30 engine oil and
straight unleaded petrol.
DO NOT mix the fuel with the oil.
You MUST check the engine oil level before each use.
▪ To add engine oil, remove the attachment from the power head and place of a flat, level
surface.
▪ Unscrew the oil filler cap (6).
▪ Slowly pour 60 ml of semi-synthetic 4 stroke SAE 10W30 engine oil into the crank case
until it reaches the top of the oil fill hole (Fig. 6).
DO NOT overfill. Overfilling the crankcase may cause excessive smoke, oil
loss and engine damage.
▪ Replace the oil filler cap (6) and tighten securely.
WARNING! Petrol and its vapours are highly flammable and explosive. To
prevent serious personal injury and property damage, handle it with care.
Keep away from ignition sources and open flames, handle outdoors only in
a well ventilated area.
DO NOT smoke and wipe up any spills immediately.
ALWAYS shut off the engine and allow to cool BEFORE fuelling.
NEVER add fuel to a running or hot machine.
ALWAYS refuel in a well ventilated area, away from buildings or sources of
ignition. Move at least 30 feet from the refuelling area before starting the
machine.
