The digital display will display the room
temperature.
The up- and down-arrow buttons can be
used to select full power or half power.
This is indicated by the segments to the
right of the flame symbol. Small segment
lit = half power. Both segments lit = full
power.
To set the thermostat press the TEMP
button, then press the up- or down-arrow
buttons to change the target
temperature. The thermometer symbol
will illuminate, and the digital display will
flash, showing the target temperature. After 5 seconds the display
will stop flashing and return to displaying the room temperature.
To set the timer press the TIMER button. The clock symbol will
illuminate. Then use the up- and down-arrow buttons to set the
number of hours for which the heater is to run before automatically
switching off.
Unplug the appliance from the mains when not in use. The cable
can be wrapped around the plastic cable tidy on the front panel.
USING THE REMOTE CONTROL
The remote control duplicates all the controls that are on the
control panel.
Page 3
