Bedienungsanleitung President Johnson II - 12-24V (Seite 28 von 52) (Englisch, Französisch, Spanisch, Polnisch)

636618

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

4) BASIC OPERATIONS TO BE CARRIED OUT BEFORE USING YOUR

SET FOR THE FIRST TIME (without transmitting and without using

the «push-to-talk» switch on the microphone)

a) Connect the microphone

b) Check the antenna connections

c) Turn the set on by turning the volume knob VOL (1) clockwise.

d) Turn the squelch knob SQ (2) to minimum (M position). Adjust the volume

to a comfortable level.

e) Go to Channel 20 using either the UP/DN (4).

5) ADJUSTMENT OF SWR (Standing wave ratio)

WARNING: This must be carried out when you use your CB radio for the

ﬁrst time (and whenever you re-position your antenna). The adjustment

must be carried out in an obstacle-free area.

* Using an external SWR meter (e.g. SWR 1 or SWR 2)

a) To connect the SWR meter :

- Connect the SWR meter between the CB radio and the antenna as close

as possible to the CB (use a maximum of 40 cm cable, type President

CA 2C).

b) To adjust the SWR meter:

- Set the CB to channel 20.

- Put the switch on the SWR meter to position CAL or FWD.

- Press the «push-to-talk» switch on the microphone to transmit.

- Bring the index needle to t by using the calibration key.

- Change the switch to position SWR (reading of the SWR level). The

reading on the V.U. meter should be as near as possible to 1. If this is

not the case, re-adjust your antenna to obtain a reading as close as

possible to 1. (An SWR reading between 1 and 1.8 is acceptable).

- It will be necessary to re-calibrate the SWR meter after each adjustment

of the antenna.

WARNING: In order to avoid any losses and attenuations in cables

used for connection between the radio and its accessories, PRESIDENT

recommends to use a cable with a length inferior to 3m.

Your CB is now ready for use.

B) HOW TO USE YOUR CB

1) ON/OFF - VOLUME

a) To turn the set on, turn the knob VOL (1) clockwise

b) To increase the sound level, turn the same knob further clockwise.

2) ASC (Automatic Squelch Control)/SQUELCH

Suppresses undesirable back-ground noises when there is no commu-

nication. Squelch does not effect neither sound nor transmission power,

but allows a considerable improvement in listening comfort.

a) ASC: Automatic Squelch Control

Worldwide patent, a PRESIDENT exclusivity

Turn the squelch knob SQ (2) counterclockwise to ASC position. «ASC»

appears on the display. No repetitive manual adjustment and a per-

manent improvement in listening comfort when this function is active.

It can be disconnected by turning the knob clockwise, in this case the

manual squelch control becomes active again. «ASC» disappears.

b) Manual squelch

Turn the squelch knob clockwise to the exact point where all back-

ground noise disappears. This adjustment should be done with precision

as, if set to maximum, (i.e. fully clockwise) only the strongest signals will

be received.

3) DISPLAY

Multi-functions LCD display (backlit). It allows visualizing all functions:

Shows transmission

SCAN scan function activated

AM AM mode selected

FM FM mode selected

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

President Johnson II - 12-24V Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info