Bedienungsanleitung President Johnson II - 12-24V (Seite 30 von 52) (Englisch, Französisch, Spanisch, Polnisch)

636618

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Scan of the memories

a) press MEM (9) during the scanning cycle of the channels. «MEM» is dis-

played. The transceiver scans the active memories (M1, M2, M3) and

channels 19 and 9.

b) press MEM (9) during recall cycle of the channels. «SCAN» is displayed,

«MEM» disappears.

Press PTT (11), CH19/9 (5) , DW (6) or SCAN (7) again to exit SCAN function.

M2 (see § 9)

8) AM/FM ~ LOCAL ~ M1

AM/FM

(short push)

This switch allows to select the modulation mode AM or FM.

Your modulation mode must correspond with the one of the person you

are speaking to.

AM/ Amplitude Modulation (AM) is for communications in areas where

there are obstacles and over medium distances.

FM/ Frequency Modulation (FM) is for nearby communications in ﬂat,

open areas.

AM/FM 2

function (only in U conﬁguration)

Allows to alternate the frequency bands CEPT and ENG in the U conﬁg-

uration. When the ENG frequency band is selected, «UK» is displayed.

LOCAL (long push)

This feature allows a better listening through close contact. When your

partner is close, press this button to avoid distortion.«LOCAL» is displayed.

M1 (see § 9)

9) MEM ~ F

MEM

3 channels can be memorized with following parameters: AM (except

for EC and U conﬁgurations) or FM; LOCAL; NB/ANL; HICUT (and CEPT/

ENG in the U conﬁguration)

To memorize:

- Press shortly on MEM (9), «MEM» blinks.

- Press during 1 s on M1 (8), M2 (7) or M3 (6). «MEM» is displayed contin-

uously. The channel has been memorized.

To recall a memory:

- Press shortly on MEM (9), «MEM» blinks.

- Press shortly on M1 (8), M2 (7) or M3 (6).

- «MEM» is displayed continuously. The memorized channel is active.

To delete a memory:

- Turn off the transceiver.

- Keep key M1, M2 or M3 pressed and switch on the transceiver.

- The selected memory is deleted.

F - FREQUENCY BAND SELECTION

(Conﬁguration: EU ; PL ; d ; EC ; U ; In)

The frequency bands must be chosen according to the country where

you are going to operate. Do not use another conﬁguration. Some

countries require user’s licence.

See the table on page 49.

How to proceed:

- Switch off the transceiver

- Press and hold the F (9) key and switch on the transceiver. «F» blinks and

the letter corresponding to the conﬁguration blinks.

- In order to change the conﬁguration, use the /t keys on the front

panel or UP and DN on the microphone.

- When the conﬁguration is selected, press on the F (9) key during 1 s.

«F» and the letter corresponding to the conﬁguration is continuously

displayed. At this stage, conﬁrm the selection by switching off then

switching on again the transceiver.

See tables on page 44 ~ 48.

10) 6-PIN MICROPHONE PLUG

This plug is situated on the front panel, thereby making it easier to set

the equipment into the dashboard. See the cabling diagram on page

47.

11) PTT (push to talk)

Press this knob to transmit a message and release to listen to an incoming

communication.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

President Johnson II - 12-24V Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info