Bedienungsanleitung Pride Colt Twin (Seite 40 von 48) (Englisch)

721988

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

www.pridemobility.com Colt Twin

IX. CARE AND MAINTENANCE

Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability to

perform the maintenance listed below, you may schedule inspection and maintenance at your authorised Pride

Dealer. The following areas require periodic inspection and/or care and maintenance.

TYRE PRESSURE

! If equipped with pneumatic tyres, always maintain the psi/bar/kPa air pressure rating indicated on each tyre.

WARNING! It is important that the psi/bar/kPa air pressure rating indicated on each tyre be

maintained in pneumatic tyres at all times. Do not underinflate or overinflate your tyres.

Low pressure may result in loss of control and overinflated tyres may burst. Failure to

maintain the psi/bar/kPa air pressure rating indicated on the tyres at all times may result in

tyre and/or wheel failure.

! Regularly inspect your scooter’s tyres for signs of wear.

WHEEL REPLACEMENT

If your scooter is equipped with pneumatic tyres and you have a flat tyre, you can have the tube replaced. If your

scooter is equipped with a solid tyre insert, either the solid insert or the entire wheel must be replaced depending on

the model. Contact your authorised Pride Dealer for information regarding replacement wheels for your scooter.

WARNING! Wheels on your scooter should only be serviced/replaced by an authorised

Pride Dealer or qualified technician.

WARNING! Completely deflate pneumatic tyres before dismantling the rim or attempting

repair.

WARNING! When changing a tyre, remove only the centre lug nut, then remove the wheel.

If any further disassembly is required, deflate the tyre completely or it may explode.

EXTERIOR SURFACES

Bumpers, tyres and trim can benefit from an occasional application of a rubber or vinyl conditioner.

WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl seat or tyre tread,

as this may cause them to become dangerously slippery.

CLEANING AND DISINFECTION

! Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter. Avoid

using products that may scratch the surface of your scooter.

! If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on

your product before application.

WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning

agent before applying it to your product. Failure to comply may result in skin irritation or

premature deterioration of upholstery and/or scooter finishes.

BATTERY TERMINAL CONNECTIONS

! Make certain that the terminal connections remain tight and uncorroded.

! The batteries must sit flat in the battery wells.

! The battery terminals should face towards the inside of the scooter.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pride Colt Twin Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info