Bedienungsanleitung Pro-form 520 ZLT - PETL59711 (Seite 16 von 28) (Englisch)

554002

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

4. Change the incline of the treadmill as desired.

To change the incline of the treadmill, press the

Incline increase and decrease buttons or one of

the numbered Quick Incline buttons. Each time you

press the Incline increase or decrease button, the

incline setting will change by 0.5 percent. If you

press one of the numbered Quick Incline buttons,

the incline will gradually change until it reaches the

selected incline setting.

5. Follow your progress with the displays.

When you select the

manual mode, a track

representing 400 m (1/4

mile) will appear in the

matrix. As you walk or

run on the treadmill, the

indicators around the track will appear in succes-

sion until the entire track appears. The track will

then disappear and the indicators will again begin

to appear in succession.

The lower left display

can show the elapsed

time and the distance

that you have walked

or run during your

workout. Each time you

change the incline, the display will show the incline

setting for a few seconds. Note: When a workout is

selected, the display will show the time remaining

in the workout instead of the elapsed time.

The lower right display

can show the speed of

the walking belt and the

approximate number of

calories that you have

burned during your

workout. The display will also show your heart rate

when you use the handgrip heart rate monitor (see

step 6).

The upper display can

show the elapsed time,

the distance that you

have walked or run, the

approximate number

of calories you have

burned, or the speed of the walking belt. Press the

Priority Display button repeatedly until the upper

display shows the information that you are most

interested in viewing. Note: While information is

shown in the upper display, the same information

will not be shown in the lower left or lower right

display.

To reset the displays, press the Stop button, re-

move the key, and then reinsert the key.

6. Measure your heart rate if desired.

Before using the

handgrip heart

rate monitor, re-

move the sheets

of plastic from the

metal contacts.

In addition, make

sure that your

hands are clean.

To measure your heart rate, stand on the foot

rails and place your hands on the metal contacts—

avoid moving your hands. When your pulse is

detected, your heart rate will be shown. For the

most accurate heart rate reading, continue to

hold the contacts for about 15 seconds.

7. When you are nished exercising, remove the

key from the console.

Step onto the foot rails, press the Stop button, and

adjust the incline of the treadmill to the lowest

setting. The incline must be at the lowest set-

ting when you fold the treadmill to the storage

position, or you may damage the treadmill.

Next, remove the key from the console and put it in

a secure place.

 Whenyouarenishedusingthetreadmill,press

the power switch into the off position and unplug

the power cord. IMPORTANT: If you do not do

this, the treadmill’s electrical components may

wear prematurely.

Contacts

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pro-form 520 ZLT - PETL59711 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info