2
How to Install the Receiver
Before the heart rate monitor can be used, the included receiver must be installed. Pages 2 through 7 of this
user’s guide include eight sections that show how the receiver is to be installed in eight different styles of tread-
mills. Look at pages 2 through 7 and find the drawings that most closely resemble your treadmill. Then,
follow the instructions in that section to install the receiver. Note: Your treadmill may not look exactly like the
treadmills shown in the drawings. If you have questions, call toll-free 1-800-999-3756.
1. Make sure that the power cord is unplugged. Remove
the indicated Screws from the Console Back (A).
Important: The Screws may be different lengths. Keep
track of which Screws were removed from which holes.
2. Peel the paper off the pad on the bottom of the Receiver
(B). Turn the Receiver so the cylinder is on the side
shown, and press the Receiver into the bottom of the
Console Base (C) in the indicated location.
A
C
Screws
1
2
C
B
Cylinder
3. Connect the Short Jumper Wire (D) to the wire on the
Receiver (B). Connect the other end of the Short Jumper
Wire to the PULSE jack on the back of the Console (C). If
there is a wire already plugged into the PULSE jack, un-
plug it. Note: The included Long Jumper Wire can be dis-
carded. The Wire Tie can be used to tie wires if needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console (C) with the 1” Screws, 1 3/4”
Screws, and 2” Screws. Important: If the Screws are
not put back into the same holes that they were
removed from, the Console will be damaged.
3
C
B
D
PULSE
Jack
