3
1. Make sure that the power cord is unplugged. Remove
the indicated Screws (A) from the Console Back (B).
2. Peel the paper off the pad on the bottom of the Receiver
(C). Turn the Receiver so the cylinder is on the side
shown, and press the Receiver into the bottom of the
Console Back (B) in the indicated location.
Connect the Short Jumper Wire (D) to the wire on the
Receiver (C). Connect the other end of the Short Jumper
Wire to the PULSE jack on the back of the Console (E).
Note: The included Long Jumper Wire can be discarded.
The Wire Tie can be used to tie wires if needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console Base (E) with the Screws (A).
B
E
A
1
2
PULSE
Jack
D
E
C
B
Cylinder
