807483
11
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
11
THE RED ERROR LED ON THE FRONT PANEL WILL BE RED IF THERE IS A FAiLURE WITH THE
OUTPUT REGULATOR.
E1
E1E1
E1
Battery reverse connection / reverse polarity (please correct).
E2
E2E2
E2
Battery open circuit protection / low DC voltage (battery not connected / or
battery voltage too low.
E3
E3E3
E3
Battery over current protection (circuit has constant current function; the
controller may be damaged if there is a problem).
E4
E4E4
E4 Load over current / short circuit protection (Turn on the load after eliminating
the error).
E5
E5E5
E5
Battery over voltage (battery damaged or battery voltage too high).
E6
E6E6
E6
PV (solar) input over voltage protection. (PV voltage has exceeded the limit).
E7
E7E7
E7
Over temperature protection, controller will automatically stop charging when
the heat sink temperature is ≥ 90°C; and will resume when the temperature is
≤ 60°C.
E8
E8E8
E8
PV reverse connection (check the voltage and correct) - please ensure polarity is
correct.
Note:
Note: Note:
Note:
Please eliminate the fault according to the error code. If the controller does not
respond after the error is eliminated remove the power source (battery). If the
error persists the controller may be damaged and may need servicing.
The system will automatically adjust the float voltage according to the ambient temperature.
If the external temperature probe is not connected (or the external temperature is <40°C), it
uses (temperature ≥ 20°C - 5°C) by default.
The voltage may vary when the input energy is insufficient to stabilize the energy required
for the float charging.
For 12/24V batteries, when the external probe temperature ≤ 0°C, the float charging voltage
is 14.1/28.2V.
For 12/24V batteries, when the external probe temperature is 0°C~20°C, the float charging
voltage is 13.8/27.6V.
For 12/24V batteries, when the external probe temperature ≥ 20°C, the float charging
voltage is 13.5/27V.
Note:
Note: Note:
Note: If internal head sink temperature exceeds 80°C, the device shall go into approxima-
tely half power mode. Shall resume normal operation when internal head sink drops below 75°C
If internal head sink exceeds 90°C, the device shall turn off. It will resume charging again when
temperature drops below 60°C.
FAILURES
TEMPERATURE SENSOR (ONLY LEAD ACID/AGM BATTERIES)
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Pro-User SCP30 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info