Bedienungsanleitung Proficare BSR 3042 (Seite 45 von 70) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814755

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

PC-BSR3042_IM 03.07.19

Maintenance and Cleaning

WARNING:

• Always switch off the appliance before servicing or cleaning and

disconnect it from the power adapter!

• Under no circumstances should you immerse the appliance in

water for cleaning purposes. Otherwise this might result in an

electric shock or re.

CAUTION:

• Do not use a wire brush or any abrasive items.

• Do not use any acidic or abrasive detergents.

NOTE:

Do not attempt to lubricate the rollers with lubricants or oil.

Ignoring this would cause signicantly more dust or dirt to

adhere to the rollers.

• Clean the housing with a soft, dry cloth without additives.

• Use a soft cloth to gently clean the sensors (12/15/20).

CAUTION:

Prior to and after each use, check that the sensors are

clean. Otherwise, the appliance may tumble down a

staircase.

• Prior to and after each use, make sure that the nozzle

and vents are clear.

• For optimum performance of the appliance, you should

empty the dust container and clean the lters after each

use.

Emptying the Dust Container and Cleaning the Filter

CAUTION:

Never wash the lters under any circumstances.

Please refer to the images on page 4.

1. Press the corresponding surface to open the dust con-

tainer compartment.

2. Fold the handle upwards and remove the dust container

from the appliance.

3. Pull the HEPA lter out of the dust container. There is still

a rubber holder around the HEPA lter. Clean the HEPA

lter by tapping the dust out of it.

We recommend replacing the HEPA lter once a year.

CAUTION:

Do not use a brush to clean the HEPA lter. Using a

brush may damage the lter material.

4. Fold the cover of the dust container upwards. Then

remove the mesh lter from the dust container.

5. Empty the dust container while holding it over a garbage

can.

6. You can clean the dust container under running water.

To clean the mesh lter, use a soft paintbrush.

CAUTION:

• Allow the dust container to air dry. Do not, however,

expose it to direct sunlight.

• Only re-insert the lters into the dust container once

it is completely dry!

7. Reinsert the lters into the dust container. Make sure that

both the HEPA lter and the mesh lter are installed

properly.

Cleaning / Replacing the Side Brushes

If the side brushes are dirty, you may clean them with clean

water. Do not use any additional cleaning agents.

If the side brushes are worn or defective, replace them with

new ones.

1. The side brushes can be easily removed by pulling them

upwards.

2. When attaching the side brushes, pay attention to the

right (R) and left (L) markings. You will nd these mark-

ings on both the appliance and on the side brush.

Storage

• Clean the appliance as described and allow it to dry.

• We recommend that you keep the appliance in the origi-

nal packaging if it will not be used for long periods.

• Always store the appliance out of the reach of children

in a dry, well ventilated place. The storage temperature

should be between 0 and 40 °C.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Proficare BSR 3042 Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info