Bedienungsanleitung ProfiCook GK 1259 (Seite 15 von 22) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814474

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

PC-GK1259_IM 30.08.23

Without Illustration

Gas pressure reducer with gas hose

(for Germany and Austria)

Mounting

Before you can use the appliance, assemble it as follows:

1. Put on the outer and inner burner rings.

2. Now insert the pot supports with the two guide lugs into

the holes on both burners.

Gas Connection

General Information

The gas hob can be operated with gas cylinders weighing

between 5 kg and 11 kg. Low pressure butane, propane and

LPG gas mixtures are approved.

Operation is also possible with camping gas cartridges. A

special pressure regulator is required for this. This pressure

regulator is not included in the scope of delivery. Ask your

specialist dealer for advice.

Your gas hob works best with propane gas and LPG mix-

tures. Butane can be used, on account of the power rating

of the appliance, the gas cylinder may however freeze. As a

result of this, the gas pressure drops and your gas hob does

not provide full power.

Use a regulator which is certied in accordance with

DIN EN 16129.

NOTE:

For information concerning the correct regulator for gas

cylinders, please consult your LPG dealer.

Regulator and Hose

These parts are supplied with the appliance. You can obtain

spare parts from your dealer or an approved LPG supplier.

Only use hoses and regulators at the pressure stated above

which are approved for LPG.

Normally, the service life of a regulator is 2 years. It is

recommended that the regulator is replaced within 2 years

of the production date.

For components marked with a maximum service life,

replacement is mandatory after the time has expired.

WARNING:

• The hose that is used must correspond to statutory

regulations.

• The use of unsuitable hoses and incorrect regulators

is dangerous.

• Before operation, make sure that you use the correct

parts.

Connecting the Gas Cylinder

A connection is established via a exible hose and the

correct low pressure regulator. The low pressure regulator

should be tted onto the gas cylinder.

1. Remove the protective cap and the thread protector on

the gas cylinder.

2. Select a suitable wrench and tighten the coupling nut

(attention: left thread) of the low pressure regulator on

the gas cylinder hand-tight.

3. Select a suitable wrench and tighten the coupling nut

(attention: left thread) of the hose on the low pressure

regulator hand-tight.

Connecting the Appliance

You will nd the gas connection on the back of the appliance.

1. Select a suitable wrench and tighten the coupling nut

(attention: left thread) of the hose on the gas hob.

2. The screw connections of the hose must be securely

connected to the appliance and the low pressure

regulator.

Finding Areas with a Bad Seal

WARNING: Check for leaks before each use!

• Never look for sections with a bad seal using a naked

ame.

• Use a leak detection spray or soapy water.

Sections with a bad seal soon become apparent in soapy

water. You need approx. 50 ml in a mixing ratio of 1:3 (liquid

soap : water).

1. Make sure that both adjustment knobs are in the

12 o’clock position (OFF).

2. Once you have connected all components as described

above, turn the gas on.

3. Spread the soapy water on the hose and all connections.

If bubbles appear at a particular point, the section has a

bad seal and it must be repaired before use.

4. Repeat the test after the repair.

5. After the test, shut the valve on the gas cylinder.

If you nd a section with a bad seal that you cannot repair,

refer the problem to a gas technician.

If You Notice the Smell of Gas

1. Close the gas valve on the cylinder.

2. Extinguish naked ames and do not use electrical

devices in the vicinity.

3. Ventilate the area.

4. Look for areas with a bad seal (as previously described).

5. If you can still smell gas, refer to your dealer or gas

specialist.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ProfiCook GK 1259 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info