815522
23
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
23 12/237021-802L
Table 23.1
With proper installation, operation, and maintenance your appliance will provide years of trouble-free service. If you do
experience a problem, this troubleshooting guide will assist a qualied service person in the diagnosis of a problem and the
corrective action to be taken. This troubleshooting guide can only be used by a qualied service technician.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
Plug in appliance -
No response.
No current to outlet. Check circuit breaker at service panel.
7 amp fuse defective. Replace fuse.
#3 snap disc tripped or defective. Reset or replace snap disc.
Control box defective. Replace control box.
Call light on. No re.
No fuel in re pot.
Out of fuel. Check hopper. Fill with fuel.
#2 snap disc may be defective. Replace snap disc.
Vacuum switch not closing, no vacuum.
Check exhaust blower is plugged in and operating.
Check vacuum switch is plugged in.
Check vacuum hose is in good condition, clear and
connected at both ends.
Check thermocouple is in good condition and
plugged in properly.
Make sure venting system is clean.
Make sure front door is closed.
Control box defective. Replace control box.
Call light on. No re.
Partially burned fuel in re pot.
Fire pot clean-out plate not closed.
Check that re pot clean-out plate is fully closed.
Clean re pot. Make sure there is no clinker in the
re pot. See Cleaning Fire Pot with Cleaning Rod
& Fire Pot Scraper on page 19.
Fire pot is dirty (missed ignition). Clinkers may have to be broken up with re pot
clean-out tool or other means.
Call light on. No re.
Unburned pellets in re pot.
Fire pot clean-out plate not closed. Check that re pot clean-out plate is fully closed.
Fire pot is dirty.
The ignition hole between the igniter bracket
and re pot is blocked.
Clean re pot. Make sure there is not a clinker in the
re pot. Clinkers may have to be pushed out of re
pot with re pot clean-out tool or other means.
Scrape with solid piece of wire.
Igniter not working.
Remove ash drawer to see if igniter is glowing red
on start-up.
Check igniter wires for good connection.
Replace igniter using 1/4 inch (6mm) male /female
spade connectors.
Control box defective. Replace control box.
Slow or smoky start-up.
Fire pot clean-out plate not closed.
Fire pot is dirty.
Check that re pot clean-out is fully closed.
Clean re pot. Make sure there is not a clinker in the
re pot. Clinkers may have to pushed out of re pot
with re pot clean-out tool or other means.
Excessive amount of fuel at start-up. Reduce feed rate using feed rate adjustment control
rod located inside hopper.
Dirty exhaust and/or venting system.
Check for ash build up in appliance, including behind
rear panels, rebox, heat exchanger, exhaust blower
and venting.
No call light. Appliance does
not begin start sequence.
Thermostat not set to a high enough temperature. Adjust thermostat above room temperature.
Snap Disc #3 tripped. Reset snap disc.
No power. Connect to power.
Fuse blown. Replace fuse.
Connections at thermostat and/or appliance
not making proper contact. Check connections at thermostat and appliance.
Defective thermostat or thermostat wiring.
Replace thermostat or wiring.
NOTE: To test thermostat and wiring, use a jumper
wire at the thermostat block on the appliance to by-
pass thermostat and wiring.
Control box defective. Replace control box.
4 4 Troubleshooting Guide
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Quadra-Fire Castile - Pellet wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Quadra-Fire Castile - Pellet

Quadra-Fire Castile - Pellet Bedienungsanleitung - Französisch - 40 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info