Bedienungsanleitung Quadra-Fire Classic Bay 1200 Pellet (Seite 18 von 40) (Englisch)

815524

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

18 7027-802M 04/23

C. General Maintenance and Cleaning

1. Types of Fuel

The type of fuel you are burning will dictate how often you

have to clean your re pot.

If the fuel you are burning has a high dirt or ash content, it

may be necessary to clean the re pot more than once a

day.

Dirty fuel will cause clinkers to form in the repot

(Figure 18.1). A clinker is formed when dirt, ash or a

non-burnable substance is heated to 2000°F (1093°C)

and becomes glass-like. See High Ash Fuel Content

Maintenance on page 22 for more details on di󰀨erent types

of fuels.

Back side of Firepot

Firepot floor left open

Figure 18.2

Clinker

Figure 18.1

NOTE: If you are just cleaning the re pot, there is no

need to unplug the insert.

3. Ash Removal from Firebox

• Frequency: Every 5 bags or weekly or more frequently

depending on ash build-up.

• By: Homeowner

a. There must not be any hot ashes in the rebox during

cleaning so allow the appliance to completely cool.

The rebox ash should be removed every time the

exhaust path is cleaned. Frequent cleaning of the

ash in the rebox will help slow down the build-up of

ash in the exhaust blower and vent system.

b. Plug in your appliance, if unplugged, and turn the

thermostat on and immediately shut it o󰀨 to start the

exhaust blower on its cycle time. It will pull y ash out

the exhaust instead of into the room.

c. Open door. Remove ash with an ash vacuum or whisk

broom and small dust pan.

d. This ash is deposited in the same ash pan as the re

pot debris. The ash pan should be emptied every time

you clean the rebox. Remember to place the ash

and debris into a metal or noncombustible container.

e. The cleaning rods must be fully closed when cleaning

is complete; see Disposal of Ashes on page 19.

4. Cleaning Ash Pan

• Frequency: Weekly or every 5 bags of fuel

• By: Homeowner

Empty into a non-combustible container and re-install ash

pan; see Disposal of Ashes on page 19.

b. Pull re pot cleaning rod OUT a couple of times to

help shake debris loose. If rod is hard to pull, it may

be necessary to use your re pot clean-out tool to

chip away material that has built up on the bottom

plate of the re pot and to push out any clinkers.

Larger clinkers may have to be removed from the top

of the re pot.

c. The re pot oor plate must be fully closed when

nished (Figure 18.2).

2. Cleaning Fire pot with Cleaning Rod & Fire pot

Scraper

• Frequency: Daily or more often as needed

• By: Homeowner

a. The appliance must be in complete shutdown and

cool and the exhaust blower o󰀨.

WARNING

Fire Risk

• NEVER pull re pot cleaning rod or

cleaning slide plates out when appliance

is operating.

• The cleaning slide plates must be fully

CLOSED when appliance is operating.

• Hot pellets may fall into ash pan and start a re or

mis-starts due to lack of vacuum.

Fire Risk

• The cleaning slide plates must be fully

CLOSED when appliance is operating.

Hot pellets may fall into ash pan and start

a re.

WARNING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quadra-Fire Classic Bay 1200 Pellet Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Quadra-Fire Classic Bay 1200 Pellet

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info