698708
11
Zoom out
Zoom in
Vorherige Seite
1/15
Nächste Seite
ENGLISH
21
20
Note:
If this display will flash the protection circuit turn off speaker in case of failure or
overload. Reset will be possible if you operate power switch (9) located at back
panel again.
Connections on the M8 rear panel
1 Balanced In Balanced XLR Inputs
2 Unbalanced In Stereo inputs
3 RCA Stereo inputs that may also be used as outputs
4 RCA / XLR Operating mode switch to forward the input signals (2)
for inputs 1 – 3
5 Mono / Stereo Operating mode switch
6 Gain Multi-stage switch used to adjust the input sensitivity.
(+3dB / 0dB / -10dB). Please mind the information pertaining
to the installation/startup.
7 Link In Input for the 12V control connection of the P8
pre-amplifier
8 Link Out Output socket used to forward the control voltage to other
devices
9 Power switch Completely disconnects the device from the power
supply
10 Power supply socket
11 Loudspeaker output A (Left Channel)
12 Loudspeaker output B (Left Channel)
13 Loudspeaker output B (Right Channel)
14 Loudspeaker output A (Right Channel)
Note:
If the buttons 4, 5 and 6 are pressed, there is a pause of about 5 seconds until all
operating points can be stabilized and the signal is released/cleared.
RC 2 Remote Control (OPTIONAL)
The AURUM amplifiers P8 / M8 / A5 / A3 and the AURUM CD players C3 / C5 / C5 DA
may be individually controlled using the RC-2 System Remote Control.
Important note:
If you want to remotely control the amplifier or CD player functions, you must use
the SELECT button to select the relevant operating mode beforehand.
Amplifier operation
1 SELECT button
2 ON / OFF button
3 MUTE
4 Volume - minus
5 Volume - plus
6 Left balance
7 Balance plus
8 Signal source
downwards
9 Signal source
upwards
14 Level setting (for
each input using
buttons 4 & 5)
15 Display brilliance
CD operation
1 SELECT button
2 ON / OFF button
3 MUTE
4 Stop
5 Repeat / Pause
6 Search backwards
7 Search forwards
8 Scan backward
through the titles
9 Scan forward
through the titles
10 File down
11 File forward
12 Repeat (title / all)
13 Shuffle
15 Display brilliance
16 Unassigned
(optional)
Repeat
RL
Select
AMP
CD
Prog.
Opt.
Random
Display
Select
AMP
CD
Select
AMP
CD
1
2
3
4
6
8
10
12
15
5
7
9
11
13
14
16
RC-II
On
Off
max. Power Consumption: 1,
2kW
Fuse:
100V / 115V:
T6.3 ,
A L250V
230V:
T3.15, A L250V
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ACHTUNG
STROMSCHLAG GEFAHR
NICHT ÖFFNEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ATENCIÓN
RIESGO DE DESCARGA ELCTRICA
NO ABRIR
DO NOT REMOVE C OVER. N O USER
-
SERV ICEABLE PAR TS
IN SIDE. REFER SERVICING TO QUALIFIED PERSONN EL.
TO REDUCE THE RISK OF ELECTRICAL SHOCK OR FIRE, DO NOT
EXPOSE THIS APPLIANCE TO MOISTURE OR RAIN.
In Out
Link
Gain
Mono / Stereo
RCA / XLR
+3 / 0
/
-10 dB
quadral GmbH & Co. KG - Am Herrenhäuser Bahnhof 26-28 - D-30419 Hannover
Handmade in Germany
®
AURUM
Balanced In
Right
Left
Mono In
Unbalanced In
Right
Left
Mono In
A
B
Right
+ +
Mono
AB
Left
+ +
Mono+
1 2 3 4 5 76 8 9
101112 1314
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Quadral Aurum P8 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info