Bedienungsanleitung Quickie Life (Seite 17 von 76) (Englisch, Holländisch, Französisch)

713887

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

ENGLISH

Quickie Life Rev.G

Fig. 6.07

3 mm

Fig. 6.08

Step tubes are used by attendants to push a wheelchair over an

obstacle. Simply step on the tube to push a wheelchair, for

example, over a kerb or step, (Fig.6.09).

CAUTION !

Sunrise Medical strongly

reccommends the use of a step

tube on any model where

attendant use is the predominant

intended use. Damage to the

backposts may occur if you

constantly use the backpost

without a step tube, as a lever to

pull back on to tip the wheelchair.

Step Tubes

Fig. 6.09

Various footboards are available on the Life. These can be

flipped up to make it easier to transfer to/from the chair. They

are described individually.

Footrest and swing away latch

When fitting the footrests these are fitted in the swung-away

position (Fig. 6.10). Then simply turn them inwards until the

interlock engages (1). To remove the footrests, use the lever (2)

and swing the footrest outwards and lift off. Check that the

footrest is correctly engaged.

The footrest will be limited by the hanger stop (Fig.6.10) in a 90°

position. This ensures that the break will not be inadvertantly

released when the hanger is swung out.

WARNING!

The footrests are not designed to be used to lift or carry

the wheelchairs with an occupant.

Hanger play adjustment

In case of play the hanger (Fig. 6.11) can be adjusted in the

field. The hanger pin (1) is tapered and the play can be reduced

when the pin is unscrewed slightly.

Take the hanger off the chair in using the release mechanism.

Use an screw driver and turn the pin (1) in the front carefully to

the left. Then test the hanger on the chair. If the hanger

mechanism is not working/catching anymore, please undo the

task slightly.

If the play is still too large and the performance not accepted,

please repeat the task.

Footrests

Fig. 6.12

Fig. 6.13

Fig. 6.11

Lower leg lengths

By undoing the clamp screw, 2 (Fig. 6.12), you can adjust the

lower leg length. Loosen the clamp screw, adjust the tube with

the footboard to the desired position.

Tighten clamp screws again (see the page on torque). Ensure

that the plastic push joint is located under the clamp screw in

the correct position.

WARNING!

Do not stand on the footplate during transfer. The chair is likely

to tip to the front when standing on the footplate. Always place

your feet securely on the ground for transfering into or out of the

chair.

Platform Footplates

The footboard can be flipped up to make it easier to transfer to

and from the chair.

The footboard can also be tilted to six different angles relative to

a level surface.

Tighten screw (1) firmly on the outer side.

By removing the clips (2) the footplate can be adjusted to three

different positions toward both the front and rear. For this

purpose, the footplate must be flipped up, (Fig. 6.13).

When finished, make sure that all screws have been properly

tightened (see the page on torque).

A minimum interval of 25mm from the ground should always be

maintained.

Fig. 6.10

One Hand Wheel Locks

Your wheelchair is equipped with two sets of wheel locks, that

operate from the left or the right side. They are applied directly

against the tires. To engage, press the wheel-lock lever forward

against the stop (Fig.6.07). To release the wheel, pull the lever

back to the original position.

• Braking power will decrease with:

• Worn tire tread

• Tire pressure that is too low

• Wet tires

• Improperly adjusted wheel locks.

The wheel locks have not been designed to be used as brakes

for a moving wheelchair. The wheel locks should therefore

never be used to brake a moving wheelchair. Always use the

handrims for braking. Make sure that the interval between the

tires and wheel locks complies with given specifications. To

readjust, loosen screws, (1), and set the appropriate interval,

(Fig.6.08). Tighten screw (see the page on torque).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quickie Life Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info