Bedienungsanleitung Quickie Life (Seite 16 von 76) (Englisch, Holländisch, Französisch)

713887

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

ENGLISH

Quickie Life Rev.G

Wheel Locks (Fig.6.01-6.02)

Your wheelchair is equipped with

two wheel locks. They are applied

directly against the tyres. To

engage, press both brake levers

forward against the stops. To

release the locks, pull the levers

back to their original positions.

WARNING!

Braking power will decrease with:

• Incorrect fitting and adjustment

of the brakes.

• Tyre pressure too low.

• Worn tyre tread

• Wet tyres

• Improperly adjusted wheel locks.

• The wheel locks have not been

designed to be used as brakes

for a moving wheelchair.

• The wheel locks should

therefore never be used to brake a moving wheelchair.

• Always use the hand-rims for braking.

Make sure that the gap between the tyres and wheel locks

complies with given specifications. To re-adjust, loosen the

screw and set the appropriate gap. Then re-tighten the screw

(Fig. 6.01, 6.02).

After each adjustment of the rear wheels, check the wheel lock

gap and re-adjust if necessary.

Brake Lever Extension

The longer lever helps to minimise

the effort needed to set the wheel

locks.

The brake lever extension is

screwed to the brakes. By raising

this, it can be flipped forward

(Fig. 6.05).

CAUTION !

• Mounting the wheel lock too close towards the wheel will result

in a higher effort to operate. This might cause the brake lever

extension to break!

• Leaning onto the brake lever extension while transferring will

cause the lever to break! Splashing water from tyres might

cause the wheel lock to malfunction.

• Incorrect mounting of the wheel lock will result in a higher effort

to operate.

• This might cause the wheel lock extension lever to break.

Compact wheel lock (Fig. 6.06)

Compact wheel locks are

underneath the seat sling and are

operated by pulling the wheel locks

towards the rear, in the direction of

the tyre. For the wheel locks to

operate correctly, they must be

pulled fully against the stops.

CAUTION!

• Incorrect mounting of the wheel lock will result in a higher

effort to operate. This might cause the wheel lock lever

extension to break!

• The mounting bolts of the brake must not be loosened and/

or re-tightened.

Fig. 6.05

Drum Brakes

Drum brakes permit safe and convenient braking for an attendant.

They can also be set with the aid of a locking lever (1) to prevent

rolling.

The lever must snap audibly into place.

Drum brakes are not influenced by air pressure inside the tyres

(Fig.6.04).

WARNING!

Drum brakes must only be adjusted by authorised dealers

Always operate the two brakes simultaneously to guarantee the

control of the driving direction!

Drum brakes can only be used as a dynamic brake to stop the

wheelchair while driving.

Always engage the wheel locks to secure the wheelchair during a

short or long stop, or for transfer.

Brakes

Fig. 6.01

6.0 Options

Fig. 6.04

Fig. 6.02

3 mm

Fig. 6.06

Standard brake

Fig. 6.03 Fig. 6.03.1

Standard brake

12mm with solid tyres

14mm with pneumatic tyres

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quickie Life Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info