Bedienungsanleitung Remington IPL6000F (Seite 8 von 95) (Alle Sprachen)

616921

Zoom out

Zoom in

Vorherige Seite

1/95

Nächste Seite

1514

ENGLISHENGLISH

TROUBLESHOOTING / STORAGE / MAINTENANCE

, i-Light Device Maintenance

F CAUTION: Before performing maintenance on your i-Light device, ensure that the power switch is OFF

and the power cord is disconnected from the base unit.

, Replacing the Bulb

1. Press the treatment head release buttons and gently pull to remove the treatment head.

2. Gently pull out the old bulb cartridge.

3. Replace with a new bulb cartridge.

F CAUTION:Whenreplacingthebulbcartridge,donottouchtheashbulbsdirectlyasthisleavesoilsand

residue.Doingsocouldreducetheeectivenessofthebulbsorcausethemtocrackduringtreatment.

4. Replace the treatment head, making sure it snaps into place.

, Storage

• Switchotheunit,unplugitandletitcooldownfor10minutesbeforestorage. 

• Storetheunitinadryplaceatatemperaturebetween15ºCand35ºC.

, Troubleshooting

Always read these instructions fully before using i-Light. Refer to this troubleshooting guide if you

experience any problems with i-Light, as this section addresses the most common problems you could

encounter with i-Light. If you have followed the instructions in this section and continue to experience

problems, please contact the Remington® Service Centre for further assistance.

The power switch is ON, but the unit is not working.

• Makesuretheunitispluggedintoaworkingelectricaloutlet.  

• Tryswitchingtoadierentoutlet.    

The unit appears to have cracks or is broken.

Do not use if the unit is damaged. If you have concerns about using the unit, discontinue use and contact

the Remington® Service Centre for further assistance.

, Frequently Asked Questions

I have switched the unit ON, but I cannot increase or decrease the energy level.

• Tryresettingtheunitbyturningitoandwaitingseveralsecondsbeforeturningitbackon.

The Bulb Status Indicator Light turns green but the unit does not ﬂash when the button

is pressed.

• MakesuretheSkinContactSensorisinfullcontactwiththeskin.  

• Tryresettingtheunitbyturningitoandwaitingseveralsecondsbeforeturningitbackon.

There is a strange smell.

• Besuretheareaiscompletelyshavedbeforetreatment.

The treated areas become red after treatment.

• Thisisnormalandtherednessshouldsubside.Ifnot,tryusingalowerenergylevel.

I have not seen optimal results or hair has begun to grow back.

• Hairmaybegintogrowbackafteryourinitialtreatment.Thisisperfectlynormal.Foroptimalresults,

repeat the treatment when you notice hair regrowth.

Note: Do not treat the same area more than once a week.

F BE AWARE: If the unit is used over an extended period of time, the unit might

automatically disable momentarily (estimated 40 seconds) to cool down. Once the unit has cooled down,

it will be ready to use again.

Intensity/Flash Mode LED Indication

AllcurrentlyselectedLEDsashing Unit is overheated and is disabled momentarily to

cool down.

IntensityLEDsashinginsequence Unitismalfunctioning.Turntheunito,waitafew

moments and try again. If problem persists, the

unit should be returned for repair.

AllLEDsashingwithwarningbeep Treatment head is removed or loose.

Audible Tones Indication

Not Full Contact Flash button was pressed while the skin contact

sensor was not fully engaged.

Replace Light Cartridge Light cartridge is missing or needs to be replaced.

Contact Sensors Stuck Flash button was pressed after the contact sensor

had been engaged since unit start up. Contact

sensor may be stuck.

, Frequently Asked Questions (www.remington-ilight.com)

Q. What is i-Light? What is Intense Pulse Light (IPL)?

A. IPL works by directing an extremely short, intense pulse of ﬁltered light into the skin. The light is

absorbed by the coloured pigments in and surrounding the hair and disables the hair follicle

temporarily, preventing hair regrowth.

Q. Who can use i-Light?

A. Both men and women can use i-Light to remove unwanted hair anywhere below the neck, and

females can use to treat facial hair below the cheekbone. i-Light has been designed for individuals with

light to medium skin tones and dark hair. Safe skin tones include white, ivory, tan, beige and light

brown only. Safe natural hair colours include black, dark brown and medium brown.

Q. What areas of my body can I treat with i-Light?

A. i-Light is designed for unisex use on areas below the neck, including the legs, underarms, bikini line,

arms, chest and back. Females can also use on facial hair below the cheekbone.

Q. What can I expect from i-Light?

A. i-Lightprovidessafeandeectivesalon-gradehairremovalusingIPLtechnology.

DNLFEIDKSFINPSK

Remington IPL6000F Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info