587878
10
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
10
REMKO ETF 360/460
Automatic defrost system
The moisture contained in the
room air condenses when cooling
and coats the evaporator fins
with rime or ice depending on the
air temperature and the relative
humidity (% RH).
The automatic defrost system that
is integrated in the unit switches the
defrost cycle on if required.
The rime or ice that has
accumulated on the exchanger
surfaces is defrosted using heat gas
as required.
This defrosting method is particularly
fast and effective, and guarantees
high dehumidification performance.
Dehumidification mode is only
paused for a short time during the
defrost phase.
The [] indicator light indicates
that the heat gas defrost cycle is
active.
Emptying the condensate container
Depending on the amount of
condensate, the integrated
condensate container must be
emptied from time to time.
If the condensate container is full,
unit operation is stopped and the
[] “Container full” indicator
light flashes to indicate this unit
condition.
1. Pull the full container forwards
and out carefully.
2. Empty the container in
a suitable location.
s
s
s
Activating the timer
You can use the timer function
to preselect automatic unit “ON/
OFF” switching functions for up to
24 hours (in 1 hour cycles).
Timer switching functions
Setting in running operation:
After the selected number of
hours, the unit switches OFF.
Setting
if the unit is switched off
(the power plug must be plugged
in to a mains socket):
After the selected number of
hours, the unit switches ON.
You can use the [] key to
activate the timer function
and the [] keys to select the
required times in 1 hour steps
(maximum of 24 hours).
The entries flash on the display []
for around 10 seconds.
Timer activation is indicated
continuously by the indicator
light [] on the control panel.
If the room temperature is
sufficiently high (approx.
20 °C), rime is generally
not formed on the fin
surface, rendering defrosting
unnecessary.
Therefore, the air dehumidifier
works economically.
NOTE
The unit can only be started up
again once the condensate container
has been inserted correctly.
NOTE
The unit can be operated via
an external timer if necessary.
NOTE
After being emptied, the
condensate container incl.
float must be checked for
damage, contamination etc.
NOTE
If the unit is switched on via
the power key, all set data is
retained if the power supply is
disconnected.
NOTE
3. Re-insert the emptied and
checked container carefully into
the unit.
The “Container full” indicator
light extinguishes and the unit
continues to run automatically.
(Observe the switch-on delay)
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für REMKO ETF360 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von REMKO ETF360

REMKO ETF360 Bedienungsanleitung - Deutsch - 20 seiten

REMKO ETF360 Bedienungsanleitung - Holländisch - 20 seiten

REMKO ETF360 Bedienungsanleitung - Französisch - 20 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info