587905
28
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
28
REMKO GPM
Gas connection
LEGEND
1 = Electric gas solenoid valve
Main burner
2 = Electric gas solenoid valve
Ignition burner
3 = Pressure regulator
4 = Electric gas safety valve
5 = Gas filter (small filter area)
6 = Vibration absorbing
connecting piece (locally)
7 = Gas filter with large filter area
(locally)
8 = Gas shut-off valve (locally)
1 2 3 4 5 6 7 8
Arrangement of factory supplied gas components
must be installed by the
installation company
Installation of the gas connection
must only take place by authorised
specialists (approved by the gas
supply company) in compliance
with the regulations applicable to
the respective type of gas.
The cross-section of the cables
must be dimensioned according
to the installed load of the unit,
total line resistance and gas supply
pressure.
The necessary gas supply pressure
(depending on the particular type
of gas) must be ensured locally.
Depending on the capacity of the
unit, the necessary gas volume
and gas pressure must be available
constantly during operation.
Connection of the unit takes place
via a R 3/4“ or R 1“ connection
with external thread.
The gas supply pipe must be
installed stress and vibration-free
using suitable, detachable unions.
The components prescribed in
the pertinent gas directives and
necessary components in the gas
pipe locally must be installed by a
qualified installation company.
Gas pressure reducers, shut-off
devices, etc., are not included in
the factory delivery and must be
provided locally.
The installation of a gas filter
without pressure regulator is also
recommended as the area of the
standard filter installed above the
gas valve is limited.
The applicable standards allow
within rooms or heating rooms a
maximum pressure of 60 mbar;
higher pressures must be reduced
prior to admission into the heating
room or room in which the unit is
installed.
Before using the unit for the first
time, the gas supply pipe must be
thoroughly cleaned and vented by
suitable means.
It must be ensured that the unit
is connected gas-tight to the gas
supply pipe.
All screwed connections of the unit
and gas pipe must be checked for
tightness.
If leak detection sprays are used,
these must comply with DIN
30657 (corrosion-free).
We reserve the right to make changes to dimensions and design in the interest of technological advances.
ATTENTION
Installation of the gas system
and supply pipes must only
be carried out by authorised
specialists.
28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für REMKO GPM 15 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von REMKO GPM 15

REMKO GPM 15 Bedienungsanleitung - Deutsch - 44 seiten

REMKO GPM 15 Bedienungsanleitung - Holländisch - 44 seiten

REMKO GPM 15 Bedienungsanleitung - Französisch - 44 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info