793543
21
Zoom out
Zoom in
Vorherige Seite
1/26
Nächste Seite
English User’s manual FRIDGE FREEZERS
7
fi210217
GB
10 Using the fridge
Switch on / off and selecting the temperature
Temperature dial (thermostat)
The temperature dial switches the appliance on and off and
sets the cooling temperature.
Switch on:
Turn the temperature dial to the right. Your fridge has
been switched on. The light in the fridge compartment
comes on. The compressor runs until the set temperature
has been reached.
Temperature settings:
Turn dial left to lowest setting = slight cooling
Turn dial right to highest setting = lowest temperature
The temperature must be set according to:
room temperature
quantity of stored food
how often the appliance is opened
We recommend a medium setting. You will soon learn,
through observation, which is the most suitable setting for
your requirements.
Switch off: Turn the dial as far to the left as possible.
The light in the fridge compartment goes off.
The compressor has been switched off.
Interior lighting (not available on all models)
For those models equipped with interior lighting, a
Switch has been built in.
When the fridge has been switched on at the temperature
dial, the light automatically comes on when the fridge door is
opened and automatically goes off when the door is closed.
The light bulb is protected by a transparent cover.
Changing the light bulb:
Replacing the light bulb:
Under no circumstances should you use a lamp with a
wattage more than that specified on the original lamp.
Unplug the fridge and switch off the main fuse.
Remove the transparent lamp cover (as far as available).
Remove the old bulb by unscrewing it and screw in the
replacement bulb.
Fit the lamp cover back in place.
See also instruction in chapter “Product overview.
LED lights may only be replaced by a qualified specialist.
There is generally no warranty for bulbs.
Temperature range
Thanks to the natural air circulation in the fridge
compartment there is a range of differing temperatures that
is suitable for the storage of different food. The coldest
areas are directly over the salad crispers, in the lowest part
of the fridge and against the back wall (suitable e.g. for
sausages and meats); the warmest areas are in the front
upper part and on the door (suitable for spread able butter
and cheese).
Arrange the food according to the following table and store it
not too tightly packed so that the air can circulate freely.
Storing food in the fridge (from the top to the bottom)
1. Door storage compartments
a) Butter, cheese
b) Eggs
c) Small jars or bottles, tins, seasonings
d) Large bottles, tins
2. Fridge compartment (shelving / glass plates)
a) Preserves
b) pastries, ready cooked foods
c) Dairy produce / meats and sausages
d) Meats and sausages
e) Vegetables, fruits, salad
Advice
Food that gives off, or absorb, slight odour or taste, as
well as liquids, should always be kept in sealed containers
or in their own packaging; high proof spirits should be
stored upright and tightly closed.
Vegetables, fruits, salad can be stored unpacked in the
salad crispers.
Plastic and aluminium foils, which can be reused, are
suitable for packing food, as are metal or glass containers.
Hot foods and drinks should always be allowed to cool
down out of the fridge.
Switching the fridge off
If the fridge has to be switched off for a long period, the
temperature dial should be set to ”0“ and the fridge cleaned
as instructed above.
While the fridge is off, leave the doors open to prevent
odours from building up.
11 Troubleshooting guide
High quality manufacturing processes and the use of the
latest refrigerating and freezing technology will ensure the
trouble-free functioning of your appliance.
If you suspect any fault, before contacting your nearest
service department directly or via your dealer, make sure
you have followed all instructions and advice given in this
user manual.
Please note:
The compressor (also known as the refrigerating motor)
must not operate continuously.
It is controlled by a thermostat, which you set on the
temperature dial and switches on automatically when the set
temperature in the appliance is exceeded and switches off
automatically when it is reached again.
Noise can be heard in every compressor - refrigerating
system when it is switched on. These noises are produced
when the motor in the compressor is running and by the
refrigerant flowing through the refrigerating system circuit.
These noises are normal and do not indicate any fault in the
functioning of your appliance.
In unheated rooms and in cold weather conditions,
condensation can build up on the outer walls of the
appliance.
This does not mean there is a fault and it will disappear
when the temperature increases.
Only call the service department, if after analysis of the
possible fault factors, you cannot find any cause for the
defect or you are not able to eliminate the fault.
Therefore first check under: ”what to do when ...“
21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Respekta KGE144 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info