Bedienungsanleitung Respekta KS88.4 (Seite 38 von 42) (Deutsch, Englisch)

793544

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

EN - 38

• Defrosting occurs automatically in

the refrigerator compartment during

operation. The water is collected by

the evaporation tray and evaporates

automatically.

• The evaporation tray and the water drain

hole should be cleaned periodically with

the defrost drain plug to prevent the

water from collecting at the bottom of the

refrigerator instead of owing out.

• You can also clean the drain hole by

pouring half a glass of water down it.

Freezer defrosting process

• Small amounts of frost will accumulate

inside the freezer, depending on the

length of time the door may be left open

or the amount of moisture introduced.

It is essential to ensure that no frost or

ice is allowed to form in places where

it will a󰀨ect the close tting of the door

seal. This might allow air to penetrate the

cabinet, encouraging continuous running

of the compressor. Thin frost formation

is quite soft and can be removed with a

brush or plastic scraper. Do not use metal

or sharp scrapers, mechanical devices or

other means to accelerate the defrosting

process. Remove all dislodged frost from

the cabinet oor. It is not necessary to

switch o󰀨 the appliance for the removal

of thin frost.

• For the removal of heavy ice deposits,

disconnect the appliance from the

mains supply, empty the contents into

cardboard boxes and wrap in thick

blankets or layers of paper to keep cool.

Defrosting will be most e󰀨ective if carried

out when the freezer is nearly empty

and should be carried out as quickly

as possible to prevent an unnecessary

increase in the temperature of the

contents.

• Do not use metal or sharp scrapers,

mechanical devices or other means to

accelerate the defrosting process. An

increase in temperature of frozen food

during defrosting will shorten the storage

life. Keep contents well wrapped and cool

while defrosting is taking place.

• Dry the inside of the compartment with a

sponge or a clean cloth.

• To accelerate the defrosting process,

place one or more bowls of warm water

in the freezer compartment.

• Examine the contents when replacing

them in the freezer and if some of the

packages have thawed out, they should

be eaten within 24hours, or be cooked

and re-frozen.

• After defrosting is complete, clean the

inside of the appliance with a solution

of warm water and a little bicarbonate

of soda, then dry thoroughly. Wash all

removable parts in the same way and

reassemble. Reconnect the appliance

to the mains supply and leave for 2 to

3 hours on setting number MAX before

introducing the food back into the freezer.

Replacing LED Lighting

To replace any of the LEDs, please contact

the nearest Authorised Service Centre.

Note: The numbers and location of the

LED strips may change according to

the model.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Respekta KS88.4 Seite 38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info