Bedienungsanleitung Respekta KS88.4 (Seite 39 von 42) (Deutsch, Englisch)

793544

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

EN - 39

6 SHIPMENT AND

REPOSITIONING

6.1 Transportation and Changing

Positioning

• The original packaging and foam may be

kept for re-transportation (optional).

• Fasten your appliance with thick

packaging, bands or strong cords and

follow the instructions for transportation

on the packaging.

• Remove all movable parts or x them

into the appliance against shocks

using bands when re-positioning or

transporting.

Always carry your appliance in the

upright position.

7 BEFORE CALLING AFTER-

SALES SERVICE

If you are experiencing a problem with

your appliance, please check the following

before contacting the after-sales service.

Your appliance is not operating

Check if:

• There is power

• The plug is correctly placed in the socket

• The plug fuse or the mains fuse has

blown

• The socket is defective. To check this,

plug another working appliance into the

same socket.

The appliance performs poorly

Check if:

• The appliance is overloaded

• The appliance door is closed properly

• There is any dust on the condenser

• There is enough space near the rear and

side walls.

Your appliance is operating noisily

Normal noises

Cracking noise occurs:

• During automatic defrosting

• When the appliance is cooled

or warmed (due to expansion of

appliance material).

Short cracking noise occurs: When

the thermostat switches the compressor

on/o󰀨.

Motor noise: Indicates the compressor

is operating normally. The compressor

may cause more noise for a short time

when it is rst activated.

Bubbling noise and splash occurs:

Due to the ow of the refrigerant in the

tubes of the system.

Water owing noise occurs: Due

to water owing to the evaporation

container. This noise is normal during

defrosting.

Air blowing noise occurs: In some

models during normal operation of the

system due to the circulation of air.

The edges of the appliance in contact

with the door joint are warm

Especially during summer (warm seasons),

the surfaces in contact with the door joint

may become warmer during the operation

of the compressor, this is normal.

There is a build-up of humidity inside

the appliance

Check if:

• All food is packed properly. Containers

must be dry before being placed in the

appliance.

• The appliance door is opened frequently.

Humidity of the room enters the

appliance when the doors are opened.

Humidity increases faster when the doors

are opened more frequently, especially if

the humidity of the room is high.

The door does not open or close

properly

Check if:

• There is food or packaging preventing the

door from closing

• The door joints are broken or torn

• Your appliance is on a level surface.

Recommendations

• If the appliance is switched o󰀨 or

unplugged, wait at least 5 minutes before

plugging the appliance in or restarting

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Respekta KS88.4 Seite 39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info