GOVERNOR mixing
When using a Futaba GV-1 governor, this
function is used to switch the RPM of the
helicopter's rotor head. The rotor head speed can be
switched with each condition or the switch.
*The governor is used by connecting the governor speed
setting channel to CH7 (initial setting).
*When using an independent governor [ON]/[OFF] switch,
connect the AUX([ON]/[OFF]) connector of the governor to
CH8 and set the switch to CH8 (Governor2) at the Function
menu of the Linkage Menu.
Note: Always set (Control) and (Trim) to [--]
for [Governor] of the Function menu of the
Linkage menu.
●Select[GOVERNOR] atthe Modelmenuand
access the setup screen shown below by
touching the RTN button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
(Currently selected condition name)
●Unitdisplayselection:
[%]/[rpm]
●Setupscreenselection
●ACT/INH:INH(initialsetting)
●FinetuningVRsettings
●RPMadjustment
●Condition/Switchselection
Setting method
●Activate the mixing
When using this function, move the cursor to
the [INH] item and touch the RTN button to
switch to the data input mode.
Select the ACT mode by scrolling the touch
sensor.
*The display blinks.
Touch the RTN button to activate the mixing
and return to the cursor mode. (ON is
displayed.)
●RPM adjustment
Move the cursor to the rate item and touch
the RTN button to switch to the data input
mode.
Adjust the rpm by scrolling the touch sensor.
Initialvalue:50%(1500rpm)
Adjustmen t range: O F F , 0~110% ( O F F ,
1000~2100rpm)
*When the RTN button is touched for one second, the
sensitivity is reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
●Unit diplay selection
Move the cursor to the UNIT item and touch
the RTN button to switch to the data input
mode. Select the unit by scrolling the touch
sensor.
Tou c h th e R TN bu t t on to ch ange th e
operation mode and return to the cursor
mode.
●Fine tuning VR settings
Move the cursor to the [--] item and touch
the RTN button to access the selection
screen. Select the control.
*For a description of the switch selection method, see the
description at the back of this manual.
Move the cursor to the rate item and touch
the RTN button to switch to the data input
mode.
Adjust the trim rate by scrolling the touch
sensor.
Initialvalue:0%(0rpm)
Adjustmentrange:-20~+20%(-200~+200rpm)
*When the RTN button is touched for one second, the
sensitivity is reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
