●Selectthefunction name
and return to the home
screen by touching the
RTN button.
<SensorTouch™>
TIMER ST1/ST2
Timer setting
The Timer function may be set for any desired
time, i.e. engine run time, specified times for
competitions, etc. Two independent timers are
provided for your use. The timers are stored
independently with each model, meaning that
when you switch between model setups, the timer
associated with the new model is brought up
automatically.
The timers may be set to start and stop from the
motion of any switch or stick. You may set the ON and
OFF directions freely. Each timer has a capacity of up
to 59 minutes 59 seconds.
Timer setting
●Up timer/down timer setting
Move the cursor to the [MODE] item and
touch the RTN button to switch to the data
input mode.
Select the mode by scrolling the touch sensor
and touch the RTN button.
[UP]: Up timer
[DOWN]: Down timer
●Timer time setting
Move the cursor to the [ALARM] item and
touch the RTN button to switch to the data
input mode.
Set the time by scrolling the touch sensor.
[00]:[00]:[min]:[sec]
Touch the RTN button to end the adjustment
and return to the cursor mode.
●Switch setting
Move the cursor to the item of the switch you
want to set, access the switch setup screen
by touching the RTN button. Select the switch
and ON direction.
[For a detailed description of the setting method, see [Switch
Setting Method] located on the next page.]
Each timer may be set for count-down or count
up operation with a target time.
If a target time is set and the timer reaches the set
time, a buzzer sound for each count is generated.
Countdown timers sound one short beep during
the last twenty seconds and two short beeps during
the last ten seconds before reaching the target, then
a long tone at the target time, and continue counting
with displaying a minus (-) sign. Count-up timers
also beep the last twenty and ten seconds, beep the
target time, and keep counting upwards until shut
down.
[START]: Start/Stop switch
[RESET]: Reset switch
●Memory setting
Move the cursor to the [MEMORY] item and
touch the RTN button to switch to the data
input mode.
Select the mode by scrolling the touch sensor
and touch the RTN button.
[OFF]: Memory function OFF
[ON]: Mode where the timer is not reset when
turned power off and switched the model.
Timer operation
● TimerST1 and ST2 are started/stoppedby
pre-selected start/stop switch.
● Toreset atimer,operate thepre-selected
reset switch, or move the cursor to the [RESET]
display on the timer screen and touch the
RTN button.
●Select ST1or ST2atthehomescreen and
call the setup screen shown below by
touching the RTN button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
